61541, 61542, 61543, 26377
REPLACING HEADLAMP
OR PLOW HARNESS
INSTALLATION INSTRUCTIONS
WESTERN PRODUCTS
P.O. BOX 245038
MILWAUKEE, WI 53224-9538
A DIVISION OF DOUGLAS DYNAMICS, L.L.C.
Lit. No. 27843 Printed in U.S.A. August 6, 2002
Western Products reserves the right under its Product Improvement Policy to change construction or design details and furnish equipment
when so altered without reference to illustrations or specifications used herein. Western Products and the vehicle manufacturer may
require and/or recommend optional equipment for snow removal. Western Products offers a limited warranty on the snowplows and
accessories. See separately printed page for this important information. The following is a registered ® trademark of Douglas Dynamics,
L.L.C.: WESTERN®.
3 Brown Wires
(Park Lamp Wires)
2 Red Wires
1 Gray Wire
(Turn Signal Wires)
Black/Orange Wire
Lt Blue Wire
White Wire Black Wire
3 Brown Wires
(Park Lamp Wires)
2 Red Wires
1 Purple Wire
(Turn Signal Wires)
Black/White
Wire
White/Yellow Wire
Blue/Orange Wire
Black/Orange Wire
Use crimping pliers to crimp
furnished closed end
connector onto three wires
as shown for each park/turn assy.
No copper or loose strands
of wire should be visible
beyond open end of connector.
11-PIN HEADLAMPS
Passenger-Side Headlamp
Driver-Side Headlamp
/