Tap Installation
www.abey.com.au
KTA011KTA011
24
16
17
18
19
15
14
8
11
12
13
9
10
4
2
3
5
6
7
23
22
21
20
1
Parts List
4 O-ring
1 Spout
6 Screw
7 Facuet body
9 O-ring
10 Locking Screw
12 Steel washer
19 Handle cap
20 Cover
21 Screw
22 Pin lever
16 Cartridge
17 Locking Nut
18 Cover
cold
hot
8 Base
23 Aerator
24 Flexible hose
2 Guide washer
3 Guide sleeve
5 Guide nut
235mm
350mm
270mm
Care and Maintenance
operate the handle and pull-out hand shower during use. When installing
Notes
1.
cleaned.
2.
and tap to remove grit. Then re-insert the screen.
3.
Working Specifica�ons
Working pressure: 20-100 psi
Working temperature: 1-60°C
This tap must be installed in accordance with the AS/NZS 3500 series
standard. All Abey taps are stongly recommended to be installed by
Flush the wall valves to ensure no grit enters
Step 4
SINK WALL
WALL
HOT
KTA011KTA011
Insert the tap into the countertop and ensure
the O-ring (9) is secure in the groove of the tap
body. Then slide the washers (11 and 12) onto
the threaded body of the tap followed by the
nut (13) in the order shown in the diagram.
Tighten the nut (13) by hand and ensure the tap
is correctly aligned above the countertop.
Step 3
Locate a hole centre in the countertop at
least 50mm from the wall and with enough
If you need to locate the tap within these
diameter into the countertop .
Step 2
Step 1
water to the rigid pipe with red marking.
SINK WALL
WALL
A
B
KTA011
SINK WALL
WALL
etc has entered the tap you can easily remove
Step 5
Troubleshoo�ng
2. If the water stream is uneven it is possible that debris or grit has blocked the
will not rotate.
-
1
-
2
-
3
-
4
Gareth Ashton KTA011-B User manual
- Category
- Faucets
- Type
- User manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI