Hobart Data GateWeigh Installation guide

Brand: Hobart

Model: Data GateWeigh

Type: Installation guide

Data GateWeigh Installation

You can install Data GateWeigh on Windows 95, 98, Windows NT 4.0, and SCO OpenServer. Refer to

the following table for appropriate instructions and requirements.

ATTENTION: Your access code is 0817-08170.

(Use it when installing Data GateWeigh for Windows 95, 98, or NT 4.0.)

Windows 95, 98, and NT 4.0 SCO OpenServer

Windows 95, 98, and NT 4.0

platforms require:

• IBM PC compatible with Intel™

80486, equivalent, or higher

microprocessor.

• RAM memory of 8 MB or larger.

• Available Hard Disk space of 10

MB or larger.

SCO OpenServer platforms require:

• Intel™ 80486 processor, equivalent, or higher, and

supporting architecture.

• SCO OpenServer version 5.0.4 or greater (contact

your Hobart representative if you use an earlier

version).

• Minimum of 8 MB of RAM and 15 MB of HD.

To install Data GateWeigh:

1. INSERT the Data GateWeigh CD-

ROM into your CD-ROM drive. In most

situations, Windows will automatically

detect and run the installation. If

Windows automatically runs the

installation, skip to step 5; if not,

continue to step 2.

2. CLICK Start.

3. SELECT Run.

4. ENTER e:\setup.exe (where e: is your

CD-ROM drive) and PRESS [ENTER].

5. ENTER your name, organization, and

access code (located at the top of this

page) and PRESS [ENTER].

6. READ and PRESS [ENTER] to accept

terms of License Agreement.

7. SELECT the default directory or enter

the applicable directory for your needs

and PRESS [ENTER].

8. SELECT the default folder name, or

TYPE a new folder name, or SELECT

one from your existing folders list and

PRESS [ENTER].

9. PRESS [ENTER] to complete

installation.

To install Data GateWeigh:

1. CREATE a Data GateWeigh user into your UNIX system

(the typical Hobart user name is hobart.) Contact your

System Administrator if you need help.

2. LOG on to the UNIX system as the Data GateWeigh

user in order to install the application. Do not perform

the installation procedure as super user/root

because the directories created may be inaccessible

to you when you log in as the Data GateWeigh user.

3. CREATE a subdirectory in your home directory (for

example "dg") and make it the current directory.

4. INSERT the disk labeled Data GateWeigh Disk 1 in

your floppy drive.

5. TYPE tar xvf "floppy-disk-device-name" at the

prompt, and PRESS [ENTER] (i.e. $tar xvf /dev/fd0). If

you don’t know the name of your floppy disk device or if

the tar command fails, contact your System

Administrator.

6. INSERT the disk labeled Data GateWeigh Disk 2, when

you are prompted for the second disk, then TYPE tar

xvf "floppy-disk-device-name" and PRESS [ENTER].

7. INSERT the disk labeled Data GateWeigh Disk 3, when

you are prompted for the third disk, then TYPE tar xvf

"floppy-disk-device-name" and PRESS [ENTER].

8. TYPE ./install.sh at the prompt, and PRESS [ENTER].

F-34605 (Feb. 2001)

Hobart Data GateWeigh Installation guide

Hobart Data GateWeigh Installation guide

Hobart Data GateWeigh Installation guide

Related papers

Other documents