Kawasaki 14475 Hard Coated Polycarbonate Windshield User manual

Hello! I've reviewed the user manual for the EMP MULE PRO-MX 14475 Windshield. This document details the installation process, including how to attach the rubber straps, slide vents, and edge trim. The manual also outlines the tools required and important notes regarding the protective film. I'm ready to answer any specific questions you may have about this windshield or the installation process.
What vehicles does this windshield fit?

What tools are needed for installation?

What should I do before removing protective film?

EMP P/N - 14475

KAWASAKI MULE PRO-MX

Hard Coated Polycarbonate Windshield

Fits: 2019-2022 MULE® PRO-MX

Includes:

1. (1) 14475-01 Windshield

2. (2) 13750-03 Slide Vents

Hardware Kit:

1. (8) Rubber Fast Strap (11651)

2. (4) 1/4” x 1-1/4” Fender Washer-

Black (used between vents and

windshield as a spacer)

3. (4) Female Thumbscrew, 1.72” Dia.

(BR-F4-B-21)

4. (4) 1/4-20 x 3/4” Carriage Bolt

(must be 3/4”)

5. (2) 3/16” x 48” Bubble Edge Trim

(13623-TIM)

6. (1) EMP® Logo Decal

Tools Needed:

1. Phillips screw driver

2. 7/16” Wrench

Installation should be performed

by a certified technician.

NOTE: Once the protective film

is removed this item can not be

returned. Check for fitment

before removing film.

Installation:

1. Peel back the film along the top,

bottom and along the sides

exposing the slots.

2. Attach the rubber fast straps to

the slots as shown. The big

washer goes in the front.

Do not fully tighten yet.

3. Slide the bubble edge trim over

the top and bottom.

4. Remove the film from both sides

of the slide vents and around the

vent hole pattern in the

windshield.

5. Attach the slide vents using the

carriage bolts, large washers and

thumbscrews. The washers will

go between the vent and the

windshield. Insert the carriage

bolt in from the front, then the

washers, then the vent and

finally the thumbscrews.

6. Once assembled place on your

Mule and fully tighten the

hardware.

7. Your installation is complete.

www.ExtremeMetalProducts.com

Fig.1

Fig. 2

Fig. 3

Fig 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8