Facom BC128 Owner's manual

Page is loading ...

6

SAFETY INSTRUCTIONS :

Precautions:

- Carefully read these instructions before use.

- Battery acid is extremely corrosive. Take all suitable precautions.

- Disconnect from the mains before connecting the charger to the battery.

- Never charge batteries in an explosive atmosphere, ensure good ventilation and do not use close to a ﬂ ame.

- The charger must be placed on a stable surface and must not be covered or exposed to direct sunlight.

- FACOM chargers BC124, BC128 et BC2430 must only be used to recharge rechargeable LEAD/ACID batteries.

- Do not use a damaged charger.

- Charger servicing and repair must only to be carried out by FACOM or an approved repairer using only FACOM

spare parts

>ÃÊV>Li

*ÕÃ

V«Ã

Ài`

ÕÃ

V«Ã

L>VÊ

>ÌÌiÀÞÊÌiÃÌiÕÀ

ÀÀÀÊ`V>ÌÀ

>À}}Ê`i

-iiVÌÊLÌÌ

BC124

ÌÀLiÊV>Li }>ÀiÌÌiÊV>Li

1

BC124

830371

NU-BC/0109

Notice d’instructions

Instruction manual

Bedienungsanleitung

Gebruiksaanwijzing

Guia de instrucciones

Istruzioni per l’utilizzo

Manual de istruções

Instrukcja obsługi

Brugsanvisning

ȆİșȗȔıȣ ȥȢȓĲıȧȣ

BC128

830389

BC2430

830397

NU-BC_0109.indd 6NU-BC_0109.indd 6 04/02/2009 11:35:3504/02/2009 11:35:35

7

EN

TECHNICAL DATA:

HOW TO RECHARGE A BATTERY.

Initially, the charger must not be connected to the mains. Connect the clips to the battery.

-Red clip on the positive (+) terminal.

-Black clip on the negative (-) terminal.

The charger will then operate in test mode, and the battery charge level will be shown:

The battery does not need recharging.

The battery can be recharged.

The battery must be recharged..

BOOST mode must be used.

If the LED is ﬂ ashing, the battery must be immediately recharged.

The battery charge display will vary during charging until the maximum level is reached. When the maximum level is reached, the

indicator will ﬂ ash for a few minutes. This indicates that the charger is performing a ﬁ nal test on the battery. If the result of

this test is inconclusive the indicator will light and the battery is unserviceable. If the result of the test is positive the indicator

will remain on.

No display:

The polarities may be reversed, the battery may be incorrectly connected, or permanently unserviceable.

BC124 BC128 BC2430

BATTERY VOLTAGE

12 V 12 V 12 V and 24 V

GUARANTEE

2 YEARS 2 YEARS 2 YEARS

BATTERY CAPACITY

3 Ah to 80 Ah 20 Ah to 160 Ah 90 Ah to 600 Ah

EFFECTIVE POWER

60 W 120 W 450 W

MAX. EFFECTIVE

CURRENT.

4 A 8 A 30 A

TRADITIONAL CHAR-

GER EQUIVALENT

10 A 16 A 50 A

Red clips

Black clips

NU-BC_0109.indd 7NU-BC_0109.indd 7 04/02/2009 11:35:3704/02/2009 11:35:37

8

SELECTING THE CHARGING MODE

To be used for all standard cases.

To be used for small motorbike type batteries,

the current is then limited to 1A. This function is only available on charger BC124.

To be used for AGM batteries and when the temperature is below -5°C

To be used to attempt to repair a heavily discharged battery. To start the BOOST mode, hold down the selector button for 5

seconds. The cold and normal indicators will light simultaneously.

The BOOST mode remains enabled for between 30 minutes and two hours depending on the condition of the battery.

If, after two hours, the error indicator comes on, the battery is then unsalvageable.

This function is only available on chargers BC128 and BC2430.

This function can be used to maintain a permanent power supply to the vehicle. In the event of overload, the fault indicator

will ﬂ ash. A high overload condition will cause the charger to shut off.

This function is available on chargers BC128 and BC2430.

Caution: the arcing and overvoltage protection functions are disabled in this mode.

12V 24V SÉLECTION

The FACOM BC2430 charger can operate at 12 V or 24 V. The selection is made automatic.

Multizone adaptive charging.

Multizone adaptive charging rapid charging without risk for the either battery or the vehicle electronics.

It can recharge batteries to their maximum capacity and correctly charge very ﬂ at batteries.

Each charging zone is optimised to ensure fast, efﬁ cient charging. The charger automatically selects the charging zone to suit the battery.

- Soft charge. This is used for heavily discharged batteries.

- Regeneration. This mode prepares slightly sulphated batteries to receive and store a charge. This is essential for batteries that have not

been used for long periods.

- Bulk charge. Constant current charging, used up to 85% of the battery’s charging capacity.

-

Absorption charging.

Constant voltage charging, used between 85% and 98% of the battery’s rated charging capacity.

-

Après charge.

Charge augmentée à tension constance, cette charge est utilisée au delà de 98% de la capacité nominale de la batterie jusqu’à 100%.

- Test. The test function cheeks whether the battery is able to receive a charge..

- Maintenance. This mode allows the charger to remain permanently connected to a battery. The battery capacity is continually monito

red and regular charging performed to maintain the battery at 100%

NU-BC_0109.indd 8NU-BC_0109.indd 8 04/02/2009 11:35:3904/02/2009 11:35:39

9

EN

- BOOST reactivation. This mode can be used to reactivate a battery that is left unused for a long time.

A maximum of four 30-minute cycles are performed. After each cycle, the tester checks the battery, and switches to charging mode

at the earliest possibility. If after 4 cycles, the battery is unable to be charged, the error indicator will light and the battery

is unserviceable. This function is only available on chargers BC128 and BC2430.

MALFUNCTIONS

The warning LED ﬂ ashes:

- The terminals are not connected to the battery.

- The mains cable is not connected or powered.

- Power supply: overvoltage the battery voltage falls too quickly,

meaning that the charger is not sufﬁ ciently powerful for the battery.

- The battery is permanently unserviceable.

The warning LED remains continuously lit:

Before charging.

- Overvoltage due to 12 V charger on 24 V battery

- Wrongly connected terminals (Positive on negative and vice versa)

During charging.

- The battery cannot be charged within the safety limit. A second charging cycle can be performed, however, or use BOOST mode can be

used (BC128 and BC2430).

If nothing occurs after connecting the charger to the battery: the polarities are reversed or the battery is permanently unserviceable.

Guarantee

Your FACOM battery charger is guaranteed for two years from the date of purchase.

This guarantee excludes the cables and incorrect use.

Your FACOM battery charger must only be repaired only by the FACOM after sales service.

Dismantling the charger will render the guarantee null and void.

If you have any queries about using your charger, please contact your FACOM dealer.

NU-BC_0109.indd 9NU-BC_0109.indd 9 04/02/2009 11:35:4004/02/2009 11:35:40

Page is loading ...

42

En France, pour tous renseignements techniques sur l'outillage à main, téléphonez au : 01 64 54 45 14

BELGIQUE

LUXEMBOURG

FACOM Belgie B.V.B.A.

Egide Walschaertsstraat 14-16

2800 MECHELEN

BELGIQUE

✆

: +32 (0) 15 47 39 35

Fax : +32 (0) 15 47 39 71

NETHERLANDS

FACOM Gereedschappen BV

Martinus Nijhofflaan 2

2624 ES DELFT

P.O. BOX 1007. 2600 BA Delft

NETHERLANDS

✆

: 0800 236 236 2

Fax : 0800 237 60 20

DANMARK

FINLAND

ISLAND

NORGE

SVERIGE

FACOM NORDEN

Nordre Strandvej 119B

3150 HELLEBÆK

DENMARK

✆

: +45 49 76 27 77

Fax : +45 49 76 27 66

SINGAPORE

FAR EAST

FACOM TOOLS FAR EAST

N° 25 Senoko South Road

Woodlands East Industrial Estate

Singapore 758081

SINGAPORE

✆

: (65) 6752 2001

Fax : (65) 6752 2697

DEUTSCHLAND

FACOM GmbH

Otto-Hahn-Straße 9

42369 Wuppertal

DEUTSCHLAND

✆

: +49 202 69 819-329

Fax : +49 202 69 819-350

SUISSE

ÖSTERREICH

MAGYARORSZAG

ČESKÁ REP.

FACOM WERKZEUGE GMBH

Ringstrasse 14

8600 DÜBENDORF

SUISSE

✆

: 41 44 802 8093

Fax : 41 44 802 8091

ESPAÑA

PORTUGAL

FACOM Herramientas S.L.

Poligono industrial de Vallecas

C/Luis 1°, s/n-Nave 95 - 2°Pl.

28031 Madrid

ESPAÑA

✆

: +34 91 778 21 13

Fax : + 34 91 380 65 33

UNITED

KINGDOM

EIRE

FACOM-UK

Europa view

SHEFFIELD BUSINESS PARK

ENGLAND

✆

: (44) 114 244 8883

Fax : (44) 114 273 9038

ITALIA

SWK Utensilerie S.r.l.

Via Volta 3

21020 Monvalle (VA)

ITALIA

✆

: (0332) 790 381

Fax : (0332) 790

307

POLSKA

FACOM Tools Polska Sp. zo.o.

ul.Modlińska 190

03-119 Warszawa

POLSKA

✆

: (48 22) 510-3627

Fax : (48 22) 510-3656

FRANCE

&

INTERNATIONAL

Société FACOM

6-8, rue Gustave Eiffel B.P.99

91423 Morangis cedex

FRANCE

✆

: 01 64 54 45 45

Fax : 01 69 09 60 93

http:/ /

www.facom.com

Europa link

SHEFFIELD S9 1 XH

Stanley Deutschland GmbH

NU-BC_0109.indd 42NU-BC_0109.indd 42 04/02/2009 11:36:2904/02/2009 11:36:29

Facom BC128 Owner's manual

This manual is also suitable for

Facom BC128 Owner's manual

in other languages

Related papers

Other documents