Minka Group 3552-588 User manual

Type
User manual
INSTALLATION INSTRUCTIONS
Item#3552-588, 3553-588, 3554-588
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
MOUNTING THE FIXTURE (Fig.1)
1.
Shut off the power at the circuit breaker and remove
the old fixture from wall, including the old mounting
hardware.
2. Carefully upack the new fixture and check that all parts
are included as shown in the illustration.
3. Attach the mounting plate (A) to the outlet box using
the outlet box screws (B) (Size: #8-32N*L0
.5”). The
side of the mounting pl
ate marked “GND” must face
out.
CONNECTING THE WIRES (Fig. 2)
4. At this point, c
onnect the electrical wires as shown in
Fig. 2, making sure that all wire connectors are
secured. If your outlet box
has a ground wire (green or
bare copper), connect the fixture’s ground w
ire to it.
Otherwise, connect the fixture’s ground w
ire directly to
the mounting plate using the green s
crew provided.
After wires are connected, tuck them
carefully inside
the outlet box.
FINISHING THE INSTALLATION (Fig.1)
5. Place back plate (D) over mounting plate (A),
fasten
with screws (C) by using Phillips
screwdriver (not
included).
7. Install the light bulb(s) (G) (supplied) in accordance
with the fixture’s specifications. (DO NOT EXCEED
THE MAXIMUM WATTAGE RATING!) (
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
6.
Place the glass shade (H) over socket cup (F). Using
screws (E) secure glass shades to socket cap above
socket cup (F).
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXT
URE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
Set
#
-Mounting Plate
-Ground Screw
-Outlet Box Screw*2
A-021-170122
Glass# G3551
This figure is only for referece.
C
Outlet Box
A
B
D
G
F
E
D
H
  • Page 1 1

Minka Group 3552-588 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI