Frontal Height
1220mm
Frontal Height
716mm
1833mm
140mm
140mm
24mm
25mm
10mm
140mm
140mm
Bosch 70:30 Combi Fridge Freezer
Assembly & Application Information
The details below show how to t the 70:30 Combi Fridge Freezer into the appliance tower cabinet.
Introduction
Application
The illustration below shows how to prepare the tower cabinet to house the appliance.
Position the top shelf following the dimensions below and place two shelves at the base of the cabinet
as shown. For all other aspects of cabinet installation, please refer to the kitchen installation manual
(pages 44 - 52).
Cut out the shelf using the dimensions
given, to allow the shelf to t over the
hinge plate.
Note: The top shelf position will require drilling as
this is 32mm above the existing holes.
Cut out bottom shelves to allow for
ventilation.
Secure the base shelves together
using the 25mm screws provided
Note: When tting hinges to your side
panel, make sure the correct hinge hole
positions are used, in relation to the door
drillings (see below)
LH Door
A B C
LH/RH
Door
RH Door
A
B/C
A/B/C
A/B/C
Top back panel (behind cupboard)
Height 118mm
70/30 Fridge
Freezer Tower
Issue:22/06/2010
