natural NATSG600 User manual

FORLAMINATES,HARDWOODANDENGINEERED

Installationinstructions

1.Checkfornails.

2.Sweepormop.

3.Rollout1widthofmembrane.

4.Cutrollatwall.

5.Installflooringplanks.

6.Rolloutnextwidth.

7.Sealseamsusingtheattachedtapebyremovingpaperstripandpressingthetapedownto

adheretomembrane.

Repeatsteps3to7untilflooriscompleted.

NOTE:WheninstallingNaturalSGinbasementorwhereamoisturebarrierisrequired,extendtheunderlayment1”-2”upthe

sidesofallwalls.ToensurethevaporbarrierqualitiesofNaturalSGaremaintained,avaportapeisrequiredtosealallseams

thatarenotsealedbytheSealGuardsystem.Newconcreteshouldcurefor60-90daysminimum,beforeinstallingflooring

products.Checkforexcessivemoistureinvariousareasbeforeinstallationreferringtoflooringmanufacturer’srecommendations.

Consultwithyourflooringspecialistforadditionalinstructions.



This manual is also suitable for

Download PDF