2. BLOTZ
  3. B28-SF-232

BLOTZ B28-SF-232 Assembly Instructions

  • Hello, I'm a chat assistant and I've reviewed the instructions for the BLOTZ B28-SF-232 door model assembly. This document describes how to build the 28mm door model, explaining the steps for assembling the frame, wheel and axle. I am ready to answer your questions about it.
  • What kind of glue is required?
    What tools are needed for assembly?
    What are the main steps of construction?
28mm Doors #1
B28-SF-232
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Each door is made from the components shown above.
Glue the axle to the centre of the wheel.
Stick the frame to the door.
Glue the wheel to the door, then trim off the excess
axle that protrudes from the back of the door.
The completed doors
The doors once painted.
/