QUAD
®
FOAM
DUAL USE - GUN OR STRAW
IT’S LIKE
ARMOR
AGAINST
AIR AND
MOISTURE.
14°F
COLD TEMP.
APPLICATION
FOAM PRESSURE
/
EXPANSION
LOW
MED.
HIGH
10
min.
QUICK
SETTING
10
min.
QUICK
SETTING
R5
/
INCH
INSULATION
VALUE
INSULATION
VALUE
INSULATION
VALUE
COME GET SOME AT
OSITOUGH.COM
RE-USABLE
STRAW WITH
OSI FOAM
CLEANER
UPGRADED TRIGGER DESIGN
•
Better control with foam
application & bead size
LONG 5” PRO SIZE STRAW
• Permanently attached to
the trigger
PRO
GUN
GUN
PERFORMANCE
• Higher yield vs straw
• No waste - full use with gun
• Precision control with
adjustable bead size
STRAW
STRAW
PERFORMANCE
• Convenience - quick use
• No additional tools needed
NEW & IMPROVED:
NEW &
IMPROVED!
©Henkel Corporation 2018/51891
SIDE VIEW SIDE VIEW
TOP VIEW
1. Remove cap covering the valve.
2. Connect the straw to the can by inserting the tab end into the hole in
the can’s threaded adapter and turn 90 degrees.
3. Slowly, but firmly push the trigger into the can’s valve. A slight click
indicates proper connection. CAUTION: pushing too hard to connect
can cause foam to dispense.
4. With the valve end of the can down, squeeze trigger to dispense foam.
Adjust bead size by applying pressure to the trigger. Seal perimeter
around window or door rough opening. Fill gap approximately 30%.
5. If not in use for more than 5 min, remove straw and clean with OSI
Foam Cleaner or acetone to avoid hardening in the straw.
For cleaning, the straw can be clicked onto the Foam Cleaner valve.
UPGRADED TRIGGER DESIGN
How to Attach Straw to Can
Visit OSITOUGH.COM for complete technical data sheets
/
