LOKATSE HOME AC18801B Operating instructions

Type
Operating instructions

This manual is also suitable for

ASSEMBLY INSTRUCTION
Please read the instruction carefully before assembly.
Part # Reference Image Description
Front leg
Rear leg
Chair back
Chair base
Left armrest
QTY
A
2
2
1
1
1
B
C
D
E
F
Right armrest
1
G
Cushion
1
H 4
I
Screw
(M8×45)
8
J
Hex key
1
K
A
B
C
Please check and make sure you have
all the parts available before you start
with the assembly.
Assembly should be performed on a
clean and soft surface, e.g. flat carton
box can be used.
E
F
D
G
Screw washer
8
Washer
Chair back
STEP 1
STEP 2
Repeat step 1 to screw the right armrest. Then, seal the cloth of the chair base.
STEP 3
Please stand behind the chair and gently inse t the chair back into the chair base. Firmly but gently,
push the chair back downwards until the back rest is fully slotted and locked into position.
Please make sure there is no gap between the chair back and the chair base.
Chair base
C
E
D
I
E F
D
E
F
Seal the cloth
r
Put left armrest on the ground and put one screw washer on each screw, then screw left armrest
to
Please do not tighten any screw to the end before you’ve connected all screws.
K
I
the chair base.
Please make sure the bottoms of chair base and armrest are at the same level.
CAUTION! THE CHAIR CAN ONLY BE USED ON A FLAT SURFACE TO AVOID ANY
ACCIDENTS.
Care and Maintenance
1.Do not place it near any fire, heater, or flame.
2.Do not clean it with any sharp cleaning tools as this may damage the fabric.
3.For indoor use only, avoid any patio purposes.
4.Place it in dry and cool place, avoid direct sunlight.
5.Clean it with mild soap and damp non-colored cloth.
6.Please do not write or draw on it, such stains may be permanent.
7.Children should not climb or jump on the chair.
8.Small parts-Choking Hazard- Not for children.
Imported by Festival Trading Inc.
STEP 5
Put cushion properly. Finish and enjoy you chair.
A
A
H
B
C
STEP 4
Put one washer on one front chair leg, then insert threaded leg into the mounted position. Gently
screw
the leg into chair base. Make sure the leg is screwed tightly. Repeat the same process for the other 3
legs. Please make sure the bottoms of 4 legs are at the same level.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

LOKATSE HOME AC18801B Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI