Page is loading ...
Place the KD Cams into the
holes indicated in your assembly
instructions.
(See picture A)
• Insert the KD Cam into the hole with the
arrow pointing towards the hole.
Take the piece containing the KD
Cams and slide it onto the KD Bolts
attached to the appropriate side
panels, as indicated in your
assembly instructions.
(See picture B)
Tighten the KD Cams completely
to finish this portion of the
assembly.
(See picture C)
• The KD Cam should be tightened by
turning from 190 to 230 degrees.
C
B
A
1
2
3
HOW TO Tighten KD Cams
Click here or scan this QR Code to watch the video!
• (DO) Use a soft, lightly dampened
cloth to remove smudges and
dust from your work surface.
• (DO) Use soap and water.
• (DO) Wring the cloth out before
cleaning the work surface.
A
HOW TO Clean the Surface
Click here or scan this QR Code to watch the video!
• (DO NOT) soak the work surface.
• (DO NOT) use furniture polish.
/