TECHNICAL DATA ATO-83

PROFESSIONAL GRADE

TRUCK BED COATING

Form: GDH-318

Rev.: 041014

abrasion resistance and excellent adhesion. Professional Grade

Truck Bed Coating can be applied directly to bare metal. It

provides a barrier to rust and offers excellent impact, fade and

chip resistance.

.PRODUCTS .

SKU Description

272741 Black

..PAINTING APPLICATION .

Use outdoors or in a well ventilated area such as an open

Surface must be clean and dry. Painted surfaces must be

sanded with medium grit sandpaper prior to painting.

Remove all sanding dust with a clean cloth. Protect and

mask off all surrounding areas to prevent overspray on

auto finish. Apply to bare or primed metal surface.

WARNING: If you scrape, sand, or remove old paint, you

may release lead dust. LEAD IS TOXIC. EXPOSURE TO

LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS

BRAIN DAMAGE, ESPECIALLY IN CHILDREN.

PREGNANT WOMEN SHOULD ALSO AVOID

begins to rattle. If mixing ball fails to rattle DO NOT

STRIKE CAN. Contact Rust-Oleum. Shake often during

use. Hold can upright 18-24" from surface and spray in a

rapid steady back-and-forth motion, slightly overlapping

each stroke. Keep the can the same distance from the

surface and in motion while spraying. Remove any

overspray from the auto finish immediately. For best

results, apply 2-3 coats. Allow coating to dry 20-30

minutes between coats. Do not use near open flame.

When finished spraying, wipe off tip before storing. Clean

up wet paint with xylene. Mineral spirits can also be used

to remove wet paint. Properly discard empty container. Do

not burn or place in home trash compactor.

If the valve clogs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object

into can valve opening.

TECHNICAL DATA

PHYSICAL PROPERTIES .