Page is loading ...
1
Questions, problems, missing parts with this product? Do not return to your
retailer,please call our customer service department 9:00 a.m. to 5:00 p.m.
Eastern Standard Time Monday through Friday Phone # 1-800-457-4652
or contact us at www.numarkcustomerservice.com
Geneva 3 piece bistro set
ASSEMBLY INSTRUCTIONS
SC-K-728-3EN/3 & SC-K-728-3EN/3W
Care and Maintenance
Though its powder-coated finish is rust-resistant, steel is prone to rust over time with exposure to the elements. In case of rust or scratches,
lightly sand the affected area and apply touch-up paint. To maintain the finish periodically apply wax with a soft cloth.
Wash frames with a mild solution of soap and water; rinse thoroughly. Do not use bleach or solvents.
Do not store anything on tabletop. Use furniture covers or store indoors during cold or inclement weather.
2
Parts
Hardware
right arm
left arm
front connect bar
rear connect bar
seat and back
seat cushion
back cushion
base
glass
A
B
C
D
E
F
G
H
I
2
2
2
2
2
2
2
1
1
Long bolt
Short bolt
Allen wrench
Jd x 1
Jb x 8 + 1 spare
Jc x 24
Ja x16+ 1spare
I
H
A
B
C
D
E
F
G
Assembly instruction
1
Do not tighten completely.
Repeat procedure for the other side.
A
B
C
Ja
Jc
Short bolt
Metal washer
Metal washer
Ja x 4
Jc x 4
3
Assembly instruction
2
3
Do not tighten completely.
Repeat procedure for the other side.
Do not tighten completely.
Repeat procedure for the other side.
D
C
B
A
Ja
Jc
Short bolt
Metal washer
Ja x 4
Jc x 4
E
B
A
Jb
Jc
Jc
Jb
Long bolt
Jb x 4
Jc x 4
Metal washer
4
4
Assembly instruction
5
Once all bolts are in place, go back and tighten all bolts by using Allen wrench (Jd).
Put seat cushion and back cushion on the chair.
Repeat procedure for the other chair.
Put the glass on the bace.
Now your bistro set is ready for use!
G
F
H
I
Printed in china
/
