1
OWNER’S
CARE
&
USE
MANUAL
Safety
Assembly
Operation
Care
Parts
Español, p.11
Françias, p.17
READ AND SAVE THESE INSTRUCTIONS
EVAPORATIVE
TABLETOP
HUMIDIFIER
MODEL:
E35 000 – Table-top
2-speed Fan
Portable for Versatility
Ideal for Home, Office, Dorms, or
Vacation Spots
Adjustable Humidity Level
Analog Hygrometer
Bucket Fill Design
Removable Dishwasher Safe Base
SAVE THE ENVIRONMENT
RECYCLE APPROPRIATE MATERIALS
To order parts and accessories call 1-800-547-3888
Part No. 1B72111 03/2011 Printed in China
2
General Safety Instructions
READ BEFORE USING YOUR HUMIDIFIER
DANGER: means if the safety information is not followed someone will be
seriously injured or killed.
WARNING: means if the safety information is not followed someone could be
seriously injured or killed.
CAUTION: means if the safety information is not followed someone may be
injured.
1. To reduce the risk of fire or shock hazard, this humidifier has a polarized
plug (one blade is wider than the other.) Plug humidifier directly into a 120V,
A.C. electrical outlet. Do not use extension cords. If the plug does not fully fit
into the outlet, reverse plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not change the plug in any way.
2. Keep the electric cord out of traffic areas. To reduce the risk of fire hazard,
never put the electric cord under rugs, near heat registers, radiators, stoves
or heaters.
3. Always unplug the unit before moving, cleaning or removing the fan
assembly section from the humidifier, or whenever it is not in service.
4. Keep the humidifier clean.
5. Do not put foreign objects inside the humidifier.
6. Do not allow unit to be used as a toy. Close attention is necessary when
used by or near children.
7. Never use your humidifier while any part is missing or damaged in any
manner.
8. To reduce the risk of electrical hazard or damage to humidifier, do not tilt, jolt
or tip humidifier while unit is running.
9. To reduce the risk of damage to humidifier, unplug when not in use.
10. To reduce the risk of accidental electrical shock, do not touch the cord or
controls with wet hands.
11. To reduce the risk of fire, do not use near an open flame such as a candle or
other flame source.
12. Note the warning label shown below.
WARNING: To reduce risk of fire, electric shock, or injury always unplug
before servicing or cleaning.
3
Know Your Humidifier
Description
E35 000
*Output per 24 hrs
3.5 gallons
Capacity of Unit
1.2 gallons
Sq. ft. coverage
800
Fan Speeds
2
Replacement Wick
1040
Built-in Hygrometer
Yes
Controls
Analog
ETL Listed
Yes
Volts
120
Hertz
60
Watts
90
* Based on an area with average insulation and an 8’ ceiling height.
Replacement Parts Available For Purchase
Description
Part Number
Chassis (Entire top portion of unit)
1B71890
Base
1B71891
Knob
1B71892
Wick
1040
Parts and accessories may be ordered by calling 1-800-547-3888.
Please have model number of humidifier available when calling.
4
How Your Humidifier Works
Your new Essick Air® Evaporative
humidifier is designed to satisfy home
humidity requirements through the
principle of evaporation of water in the
air.
Once the wick becomes saturated, air
is drawn in, passes through the wick
and moisture is absorbed into the air.
All evaporation occurs in the
humidifier so any residue remains in
the wick. This natural process of
evaporation creates no white dust like
some other humidifiers.
Set Up and Location
1) Unpack humidifier from carton and remove all packaging material, wick, etc.
from box.
2) Place humidifier on a flat level surface. Position the humidifier where the most
humidity is needed or where the most air will be circulated throughout the
house such as near a cold air return. If the unit is positioned close to a window,
condensation may form on the window pane. If this occurs the unit should be
repositioned in another location.
NOTE: Due to release of cool, moist air from humidifier, it is best to direct air
away from thermostat and hot air registers, and to position humidifier next to
an inside wall. Unit should not be placed where cold air from outside walls or
warm air from a hot air register blows directly on it.
3) Place the humidifier at least 4 inches from the wall.
WARNING:
For your own safety, do not use humidifier if any parts are damaged or missing
CAUTION: Do NOT position the unit directly in front of a hot air duct or radiator.
Do NOT place on soft carpet. We suggest placing the unit on a table or on a
bookshelf.
IMPORTANT: Water damage may
result if condensation starts to form
on windows or walls. Humidity SET
point should be lowered until
condensation no longer forms. We
recommend room humidity levels do
not exceed 50%.
When Outdoor
Temperature is:
F C
Recommended
Indoor Relative
Humidity (RH) is
-10°
2°
10°
20°*
-24°
-18°
-12°
-6°*
20%
25%
30%
35%
* or higher
5
Filling
Note: To avoid spillage, do not transport the unit when full of water. It is best to
separate the chassis from the base, and transport the two sections individually.
1) Lift chassis (top section) off base. Position wick in the notch at the back of the
base.
2) Before replacing the chassis, fill the base with unsoftened water. DO NOT
POUR WATER OVER THE ELECTRICAL CHASSIS. Fill the base (See
illustration) to the level marked “MAX FILL” on the center bottom of the base.
If water spills on the chassis, it must be allowed to dry completely before
turning on the humidifier. If you have only softened water available in your
home, you can use it, but you will notice a build up of minerals on the
evaporative wicks much sooner. Base capacity is 2.0 gallons. DO NOT
OVERFILL.
3) We recommend using only EPA registered bacteriostat treatment such as
Essick Air Bacteriostat, Part Number 1970 whenever you refill the humidifier
base to eliminate bacterial growth. Add bacteriostat according to the
instructions on the bottle.
4) Reposition the chassis on the base and the unit is ready for operation.
5) Plug cord into wall receptacle.
CAUTION: Disconnect power before filling, cleaning or servicing unit.
Keep grille dry at all times.
CAUTION: Do not spill water on fan motor. Electrical components must be
kept dry.
6
Controls and Operation
NOTE: The humidifier should be placed at least FOUR inches away from any walls
or curtains, and away from heat registers. Do not place on soft carpet.
Unrestricted airflow into the unit will result in the best efficiency and performance.
1) This unit has two fan speeds controlled by the lower right hand knob.
2) The humidity level knob is located above the fan speed knob. Increase
humidity by turning the upper knob from left to right.
3) The analog hygrometer in the upper left hand section displays the room
humidity.
NOTE: If excessive condensation occurs, reduce fan to a lower speed setting.
Care and Maintenance
Cleaning your humidifier regularly helps eliminate odors, bacterial and fungal
growth. Ordinary household bleach is a good disinfectant and can be used to wipe
out the humidifier base after cleaning.
We recommend cleaning your humidifier at least once a week to maintain optimum
environmental conditions from your humidifier.
We also recommend using Essick Air Bacteriostat Treatment each time you
refill your humidifier to eliminate bacterial growth. Add bacteriostat according
to the instructions on the bottle. Please call 1-800-547-3888 to order Bacteriostat
Treatment reference part number 1970.
7
Cleaning Instructions
1) Turn unit off at switch then unplug electrical cord from the wall outlet.
2) Lift off chassis from base and set aside. Carry base to cleaning basin/sink.
3) Lift wick from base, allow water to drain from wick into base and then set
aside.
4) Empty base into sink. Remove any remaining water from base with a sponge.
5) Fill base to “MAX FILL” line with water and then add 8oz. (1cup) of white
vinegar. Let solution stay 20 minutes, then empty.
6) Clean all interior surfaces of base with a soft brush. Dampen soft cloth with
white vinegar and wipe out base to remove scale.
7) Rinse base thoroughly with fresh water and remove scale and cleaning
solution.
Disinfecting Base
8) Fill base with water to “MAX FILL” line and add 3 teaspoons of chlorine bleach.
Let solution stand for 20 minutes.
9) Empty and rinse thoroughly. Refill base with water and reassemble unit.
Summer Storage
1) Clean unit as outlined in Care & Maintenance section.
2) Discard used wicks and any water in the base and allow unit to
dry thoroughly before storage. Do not store with water inside unit.
3) Do not store unit in an attic or other high-temperature area.
4) Install new wick at beginning of season.
8
ESSICK AIR PRODUCTS
HUMIDIFIER WARRANTY POLICY
EFFECTIVE APRIL 1, 2010
SALES RECEIPT REQUIRED AS PROOF OF PURCHASE
FOR ALL WARRANTY CLAIMS.
This product is warranted against defects in workmanship and materials as listed below:
One year from the date of sale on factory installed components.
Two years from the date of sale on motor.
Thirty (30) days on replacement components.
This warranty does not apply to filters or wicks which are customer replaceable parts.
This warranty applies only to the original purchaser of the product when it is purchased from a
reputable retailer/dealer.
This warranty does not apply to damage from accident, misuse, alterations, unauthorized repairs,
unauthorized use, mishandling, unreasonable use, abuse, including failure to perform reasonable
maintenance, normal wear and tear, nor where the connected voltage is more than 5% above
the nameplate voltage, nor to the equipment or products being improperly installed or wired or
maintained in violation of this Owner’s Manual.
Alterations include the substitution of name brand components including, but not limited to wicks
and bacteria treatment.
THIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE. THIS IS THE SOLE AND
EXCLUSIVE WARRANTY GIVEN BY MANUFACTURER WITH RESPECT TO THE PRODUCTS
AND, TO THE MAXIMUM EXTENT PERMITTED BY LAW, IS IN LIEU OF AND EXCLUDES ALL
OTHER WARRANTIES AND CONDITIONS, EXPRESS OR IMPLIED, ARISING BY
OPERATION OF LAW OR OTHERWISE. INCLUDING WITHOUT LIMITATION,
MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR PURPOSE.
No employee, agent, dealer or other person is authorized to give any warranties or conditions on
behalf of the manufacturer. The customer shall be responsible for all costs incurred in the
removal or reinstallation and shipping of the product for repairs.
Within the limitations of this warranty, purchaser with inoperative units should contact
customer service @ 800-547-3888 for paperwork and instructions on the return of the unit
for repair.
Notice:This warranty will be null & void if purchaser attempts to repair or replace any
parts which are mechanical or electrical.
A copy of the sales receipt is required before authorization to return a unit for repair is approved.
The manufacturer will repair or replace the product, at its discretion, with return freight paid by
the manufacturer. It is agreed that such repair or replacement is the exclusive remedy available
from the manufacturer and that TO THE MAXIMUM EXTENT PERMITTED BY LAW, THE
MANUFACTURER IS NOT RESPONSIBLE FOR DAMAGES OF ANY KIND, INCLUDING
INCIDENTAL AND CONSEQUENTIAL DAMAGE OR LOSS OF PROFITS OR REVENUES.
The warranty gives the customer specific legal rights, and the customer may also have other
rights which vary from province to province, or state to state.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
