Avery Dennison Pathfinder 6039 Operating instructions

Pathfinder 6039
Avery Dennison
Brand
Avery Dennison
Model
Pathfinder 6039
Type
Operating instructions

This manual is also suitable for

TC603XSTOI Rev AG 5/09 © 2009 Avery Dennison Corp. All Rights Reserved.
USING OPTIONAL
STRAPS
A deluxe wrist strap, a petite wrist strap, and a
shoulder strap are optional accessories for the
Monarch® Pathfinder® Ultra® Silver and Platinum
printers. The wrist straps help support the printer in
your hand, making it easier to print and apply labels.
The shoulder strap allows you to carry the printer
easily and hold extra batteries. Multiple straps cannot
be used together.
Information in this document supercedes information
in previous versions. Check our Web site
(www.monarch.com) for the latest documentation and
release information.
Attaching the Deluxe and Petite Wrist
Straps
To attach the strap to the printer:
1. Lay the strap out flat so the angled sides face up.
Deluxe Wrist Strap
Petite Wrist Strap
2
2. Turn the printer upside down, and place it on a
table so the keypad faces you.
3. Thread the right end of the strap through the right
strap holder so the angled part faces up. Move it
down and out the side. Fold the end over and
attach it to the VELCRO
®
.
4. Repeat step 3 for the left side of the strap.
5. Turn the printer upright, stick your hand through
the loop, and grab the printer’s handle. Adjust the
pad as necessary.
Strap Holder
Deluxe Wrist Strap shown
3
6. To tighten the strap, detach the part of the strap
attached to the VELCRO (behind the pad) and pull
until it is as tight as you need around your wrist.
Reattach the piece to the VELCRO to hold it in
place.
Removing the Wrist Strap
To loosen or remove the strap, detach the part
attached to the VELCRO (behind the pad) and adjust
as necessary, or remove your hand.
About the Safety Feature
The plastic loops on either side of the wrist straps are
a safety feature to protect you from personal injury.
The loops come apart and break the strap into pieces
if it gets caught on something and pulled away.
Attaching the Shoulder Strap
The parts of the shoulder strap are shown below.
Shoulder
Protector
Battery
Pouch
Length Adjustor
Strap Clip
4
To attach the shoulder strap to the printer:
1. Turn the printer upside down and place it on a
table so the keypad faces you.
2. Attach the connection ring to the right strap
holder. Then attach the strap clip to the
connection ring as shown. Repeat on the other
side.
Visit our Web site for sales, service, supplies,
information, and telephone numbers for our locations
throughout the world.
TOLL FREE:
1-800-543-6650 (U.S.A.)
1-800-387-4740 (Canada)
Co
nn
ect
i
o
n
St
r
ap
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Avery Dennison Pathfinder 6039 Operating instructions

Pathfinder 6039
Avery Dennison
Brand
Avery Dennison
Model
Pathfinder 6039
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents