FSH DB1260PTO Technical Manual

Brand
FSH
Model
DB1260PTO
Type
Technical Manual
1 V.1.0 16.05.2011
T
T
i
i
m
m
e
e
D
D
e
e
l
l
a
a
y
y
S
S
e
e
t
t
t
t
i
i
n
n
g
g
:
:
0
0
/
/
3
3
/
/
6
6
/
/
1
1
0
0
S
S
e
e
c
c
.
.
A Setting:
Case 1-
Case 2-
Case 3-
Case 4-
Case 5-
Case 6-
Power on the DB1260-PTO when door is close: Bolt will not retract if time delay setting is 0 second; Bolt
will retract if time delay setting is 3/6/10 seconds, then after a time delay (3/6/10 sec), bolt will automatically
extend. However, in these time delay periods, if door is opened and then closed again, bolt will extend right
away.
Power on the DB1260-PTO when door is open: Bolt will retract, and extend right away if door is closed.
Power on the DB1260-PTL when door is close: After a time delay (0/3/6/10 sec), bolt will automatically
extend. However, in these time delay periods, if door is opened and then closed again, bolt will extend right
away.
Power on the DB1260-PTL when door is open: Bolt will extend right away if door is closed.
Push the exit-switch when DB1260 is powered and bolt extends: Bolt will retract, and after a time delay
(3/6/10 sec), bolt will automatically extend. However, in these time delay periods, if door is opened and then
closed again, bolt will extend right away.
Push the exit-switch when DB1260 is powered and door is open: Bolt will extend right away if door is
closed.
B Setting:
Case 1-
Case 2-
Case 3-
Case 4-
Case 5-
Case 6-
Power on the DB1260-PTO when door is close: Bolt will not retract if time delay setting is 0 second; Bolt
will retract if time delay setting is 3/6/10 seconds, then after a time delay (3/6/10 sec), bolt will automatically
extend. However, in these time delay periods, if door is opened and then closed again, the time delay will
reset and count again.
Power on the DB1260-PTO when door is open: Bolt will retract. If door is closed, after a time delay
(0/3/6/10 sec), bolt will automatically extend. However, in these time delay periods, if door is opened and then
closed again, the time delay will reset and count again.
Power on the DB1260-PTL when door is close: After a time delay (0/3/6/10 sec), bolt will automatically
extend. However, in these time delay periods, if door is opened and then closed again, the time delay will
reset and count again.
Power on the DB1260-PTL when door is open: if door is closed, after a time delay (0/3/6/10 sec), bolt will
automatically extend. However, in these time delay periods, if door is opened and then closed again, the time
delay will reset and count again.
Push the exit-switch when DB1260 is powered and bolt extends: Bolt will retract, and after a time delay
(3/6/10 sec), bolt will automatically extend. However, in these time delay periods, if door is opened and then
closed again, the time delay will reset and count again.
Push the exit-switch when DB1260 is powered and door is open: if door is closed, after a time delay
(0/3/6/10 sec), bolt will automatically extend. However, in these time delay periods, if door is opened and then
closed again, the time delay will reset and count again.
If bolt is out and not in the right position, after 6 seconds, bolt will automatically retract. Later, bolt will extend right away if
door is opened and then closed again.
If bolt is out and not in the right position, in 6 seconds, bolt will automatically retract if door is opened. Later, bolt will extend
right away if door is closed again.
Note: 1. When power is on and door is close, system will automatically set 3 seconds time delay once the exit-switch is
pushed to close momentarily and if the Time Delay Setting is set to 0 second.
2. The bolt will retract when the exit-switch (Brown Wire & Yellow Wire) is pushed to close momentarily.
The bolt will remain retract ( For example: during business hours) as long as these two wires are closed.
B
B
i
i
-
-
c
c
o
o
l
l
o
o
r
r
L
L
E
E
D
D
S
S
t
t
a
a
t
t
u
u
s
s
(
(
E
E
O
O
p
p
t
t
i
i
o
o
n
n
)
)
:
:
B
B
u
u
z
z
z
z
e
e
r
r
S
S
t
t
a
a
t
t
u
u
s
s
(
(
T
T
O
O
p
p
t
t
i
i
o
o
n
n
)
)
:
:
1. Extend Successfully: Green blinks every 5 seconds. 1. Extend Successfully: Beep! Beep!.
2. Wait for Extend: Red blinks fast. 2. Extend Fail: Beep! … Beep! 10 seconds.
3. Delay Period: Red blinks slowly. 3. Retract Successfully: Beep!.
4. Wait for Delay Start: Red on. (B Setting only) Note: Set DIP4 ON/OFF to set Buzzer ON/OFF.
5. Bolt Remain Retract: Red/Green blinks alternatively.
DB1260 Series
2 V.1.0 16.05.2011
Aluminum, Metal,PVC Door Installation
10
5.5 CSK-2 Holes
Wooden Door Installation
185
20
35
Min 211.5
2
10
152
12.7
Min 164
23.5
8
15
3
0.5
66.8
Min 92
Min 93
14
16.7
26
117.6
66.8
92.8
211
235.8
26
3 V.1.0 16.05.2011
  • Page 1 1
  • Page 2 2
  • Page 3 3

FSH DB1260PTO Technical Manual

Brand
FSH
Model
DB1260PTO
Type
Technical Manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents