FRANCONE BT18 Installation guide

BT18
Brand
FRANCONE
Model
BT18
Category
Sanitary ware
Type
Installation guide
*1 Connection pipes
Please note these pieces are provided for a standard setup of
220mm between the stems.
In case of ornamental backplates or artistic spouts, please note
these pipes are not included.
You can change them for longer or shorter pieces to suit your
measurements.
Guidelines
Earth Bonding. Francone Bespoke Taps strives to continually improve so we reserve the right to
change product specifications and design.
All water fittings should only be installed by a qualified plumbing engineer.
Take extra care during installation not to damage the finish or fitting.
Before starting, flush pipes to remove debris and turn off water supply.
We recommend the fitting of isolation valves to the inlet feeds for ease of maintenance.
Optimal water pressure 3 bar. Minim water pressure 1 bar. Where water pressure exceeds 5 bar, we
suggest pressure reducing valves are fitted. For optimum performance, hot and cold water pressure
should be correctly balanced.
Inspect all connections for leaks.
Please note that the additional cartridge
stems are only necessary if you wish to fit
to a depth of between 58mm-78mm
*2 Spare cartridge stems
3 hole wall-mounted installation
Back Wall Finished Wall
Min 38 mm
Max 78mm
30-35mm
Flange
Spare cartridge stem
Spare cartridge stem
Handle
Screw
“H” Insert
Spout
Aerator
“C” Insert
Escutcheon
Nipple
Hot water
inlet
Cold water
inlet
Connection pipe
(80mm)
Threaded tube
Cartridge
Cartridge stem
Body valve
Tee piece
*1
*2
*3
*3 Threaded tubes.
Please cut these as per your needs.
  • Page 1 1

FRANCONE BT18 Installation guide

BT18
Brand
FRANCONE
Model
BT18
Category
Sanitary ware
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents