Recycle Disassemble Instruction
(Dismantled Information)
Requirements according to ANNEX VII of DIRECTIVE 2012/19/EU
on waste electrical and electronic equipment (WEEE)
Materials and components with hazardous content
LCDs may contain hazardous substances like Pb and BFRs which are covered by
exemptions under the RoHS directive. However, the majority is present in the printed
circuit boards assembly. In order to reduce emissions as much as possible, a complete
disposal of the old appliance is required. This treatment may only be performed in
authorized handling plants.
Product Name:
LCD Monitor
Model No.:
BL2581T,BL2581TE
Disassembly Tools
Tool picture
Philips Screwdriver for M3 Screw
Nosed Pliers
Diagonal Cutting Pliers
Slotted screwdriver
Six Point Sockets
Philips Screwdriver for M2.5 Screw
Knife
1.Product exploded view
2.Package view
External cable
Item Description Qty Unit
P01 USB cable 1 PCS
P02 HDMI cable 1 PCS
P03 DP cable 1 PCS
P04 POWER Cord 1 PCS
Disassembly process
1.Remove external cable(WEEE ANNEX VII)
1.1 Remove USB cable
1.2 Remove HDMI cable
1.3 Remove DP cable
1.3 Remove Power Cord
2. Remove ASSY Stand
2.1 Remove base by pressing release Screw.
2.2 Remove ASSY CLMN by hand.
3. Remove ASSY Rear Cover
3.1 Remove screw to release Rear Cover.
3.2 Remove Slider module from RC by Screwdriver and hand
4. Remove SHD and PCB.
4.1 Remove lamp wire and ctrl BD FFC & Mylar & Conductive Fabric
4.2 Remove LVDS from PANEL, and remove screw by screwdriver.
5. Remove MF and DECO from PANEL
5.1 Remove screw by screwdriver
5.2 Remove DECO by hand
5.3 Remove Sensor Holder
5.4 Remove CTRL BD FFC and CTRL BD by hand
5.4 Remove MF screw by screwdriver
Recycle characteristics
Recycle characteristics Part No.
Reuse -
Recycle 1~2,4,6,8~12,14~15,16~20,23~28
WEEE annex II 3,5,7,13,16,22, P01~04
Recovery -
Disposal 21,22
Disassembly Time
Total time: 30 minutes
/