Wiring Guide & uPyxis® Download uPyxis® Procedures
24 V +
24 V Power Ground
4–20mA +
4–20mA -
Interal Connection to Power Ground
Shield, Earth Ground
Place your ST-730 Series sensor into the
desired Pyxis Lab® Turbidity Calibration
solution, then on the uPyxis® choose a
calibration type. Enter the NTU value & select
‘Slope Calibration’. A success message will
appear & your ST-730 Series sensor is now
calibrated.
Under the ‘Diagnosis’ tab, you can conduct a
‘Cleanliness Check’, uPyxis® will then notify you
if the sensor is clean or if it is fouled. If your
sensor reads ‘Dirty’, you will need the Pyxis
Lab® Sensor Cleaning Kit.
You will need to download the uPyxis® app
& connect your MA-WB Bluetooth® Adapter
if you want to wirelessly monitor or calibrate
your ST-730 Series sensor.
