Vixen Horns VXA7160 Owner's manual

VXA7160

INSTALLATION GUIDE

PAGE 1 of 1

BEFORE BEGINNING YOUR INSTALLATION

Read through the instruction guide before getting started with the installation. Professional installation is recommended for

this product.

CONTENT

 1/4” Remote Intake Air Filter Kit

For optimal compressor performance replace the air filter regularly, replacement time frames depend on the operating

environment and how often it is used.

INSTALLATION

Use the filter when you need to move compressor’s air intake to an area other than where the compressor was

installed.

A. Remote Inlet Air Filter Housing (1 pc)

B. Remote Filter Holder with Self-anchoring Pin (1 pc)

C. Filter Element (1 pc)

D. Remote Filter Holder Screws (2 pcs)

E. 1/4" NPT Female x 1/4" Barbed Tube Fitting (1 pc)

F. 1/4" NPT Male x 1/4" Barbed Tube Fitting (1 pc)

G. 1/4" OD Air Line (10 FT)

 10 feet of air line is enclosed for attaching the remote air filter.

 Find an installation location for the remote air filter, ensuring that the location should be dry and far from a

heat source.

 Use a hose cutter, a razor blade, or a sharp knife when trimming the airline. A clean, square cut is optimal.

IMPORTANT: Do not use wire cutters or scissors to cut the air line, these tools may flatten or crimp the air

line causing it to leak.

 Place the airline all the way onto the barbed fittings or at least, until it covers two ridges and starts routing the

air line.