1
method
In order to upgrade your projector, please follow the method and sequence described below:
• You will need a USB memory stick set up with a FAT-file system to perform this upgrade
• Access the upgrade software from the following web-address; www.barco.com
notice
3
• Do not turn off projector/remove the power cord while the upgrade is still in progress!
• The projector may restart several times during the upgrade
2
download
• Download and save the firmware.zip-file to your PC desktop
• Download and save the firmware_<version>.tar file to the root of a memory stick. It is important that the USB is safely removed from computer,
using the eject function on your PC.
• Set the projector in standby mode
• Insert the memory stick in the projector and wait a few seconds
• If the projector is in standby mode it will start flashing automatically. If the projector is in a sleep mode, push the on button to initiate flashing
Rapid blue blinking indicates that upgrade is initiated
• Remove the USB stick when blue blinking turns to yellow blink. Rapid yellow blinking indicates that the upgrade process is running
Quick Start Guide
SW upgrade
finished
4
The upgrade has finished successfully when yellow rapid blink has changed to stable yellow light.
STATUS COLOR
On (active) Blue
Wait on Blue flashing
Standby (off) Yellow
Wait Yellow flashing
Lamp failure Red
Overheating Red flashing
Configure/
upgrade
Yellow fast flashing
Error Red fast flashing
Indicator light
2
www.barco.com
Please visit our web site to download required files or to seek other types of information
F50 SW upgrade
-
1
Barco F50 Panorama User guide
- Category
- Projector accessories
- Type
- User guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI