Instructions
During installation of the E2 Modules, follow the steps below to properly
document their location.
1. Affix the E2 Module Serial Number label onto the Tracking Information
Sheet (other side). The label can be found inside the E2 Module
carton.
2. Note the location of that E2 module within the enclosure - Circle
F if it is in the front of the enclosure or R if it is in the rear of the
enclosure.
3. Note the enclosure height at which the E2 is positioned - Circle B if it
is at the bottom of the enclosure, M for middle or T if located at the
top of the enclosure.
4. In the ENCLOSURE LOCATION field, enter information identifying the
enclosure in which the E2 module is positioned, e.g. Rack or Room #
5. When the Sheet is completed, submit it to the Administrators in
charge of tracking assets.
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2016 Tripp Lite. All rights reserved.
16-03-429-9335B4-EN.indd 1 4/6/2016 4:23:32 PM
E2 Module Tracking Information Sheet
E2 SERIAL No.
(affix label) POSITION
ENCLOSURE LOCATION
(e.g. Row # & Rack #)
F R B M T
F R B M T
F R B M T
F R
B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
F R B M T
KEY B = Bottom
F = Front M = Middle
R = Rear T = Top
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
16-03-429 93-35B4_RevA
16-03-429-9335B4-EN.indd 2 4/6/2016 4:23:32 PM
/