UNI-T UT209 User manual

Brand: UNI-T

Model: UT209

Type: User manual

UNI-T UT209 is a versatile digital clamp multimeter that offers a range of measurement functions for electrical work. It can measure AC/DC voltage, AC current, DC current, frequency, resistance, and capacitance. The device features a large-scale integrated circuit and dual integral A/D converter for steady operation and high reliability. It complies with safety standards and provides overload protection for all ranges.

Model UT209 is 4000-count digital clamp multimeter(hereinafter referred to as "the

Meter") characterized with steady operation, high reliability and novel structure.

The meter is designed with large-scale integrated circuits and dual integral A/D

converter as its core and offer overload protection for all ranges.

for

1 pc

damaged part,

This Meter complies with IEC 61010 Overvoltage Category (CAT. II 600V, CAT. III

300V), Pollution Degree 2 and Double Insulation standards.

is working

When servicing the Meter, use only the replacement parts with the same

model or identical electrical specifications.

Low Battery Indication

(See Figure 1)

Lever:

on which rotary switch position the functions of buttons are available.

(See Figure 2)

A.Measuring DC/AC Voltage (See Figure 3)

(See Figure 4)

during measurement.

(See Figure 5)

;

during measurement.

(See Figure 6)

E.Measuring Frequency (See Figure 7)

F.Measuring DC Current (See Figure 8)

into

4. Press the lever to open the transformer jaw, hold it tight and don't release.

The built-in components are very sensitive not only to the magnet but also to

heat and mechanical force. Any shock will cause change to the reading in the

short time.

the lever

cause ± 1%

measure

To obtain a more accurate DC current reading, follow the procedure as below:

1. Turn off the current to the tested conductor.

2. Press the lever to open the transformer jaw, and center the conductor within

the transformer jaw.

4. Turn on the current to the tested conductor, read out the reading after the

Meter is stable.

3. .

Figure 9

DC current

G.Measuring AC Current (See Figure 9)

2. Press the Lever to open the transformer jaw, hold it tight

and don't release. The built-in components are very

sensitive not only to the magnet but also to heat and

mechanical force. Any shock will cause change to the

reading in the short time.

cause

measure

AC Conversion:

UT209: AC-coupled and True RMS responded. Input the sinewave.

Non-sine

AC current

section.

Pressing

Technical Specifications

Low Battery Indication:

Opening:

Safety/ Compliances: IEC 61010 CAT. II 600V, CAT. III 300V,

Double Insulation and Pollution Degree 2.

Accuracy Specifications

Non-sine

AC Conversion:

UT209: AC-coupled and True RMS responded. Input the sinewave.

Maintenance

(See Figure 10)

P/N: 110401104374X

MAY.2018 REV. 4

UNI-T UT209 User manual

UNI-T UT209 User manual

Related papers

Other documents