Edelbrock E-Series Cylinder Head Bolt Kit #85562 for Pontiac w/ heads Installation guide

Type
Installation guide
®
Head Bolt Kit for 1965-79 Pontiac 389-455 c.i.d. V8
with Edelbrock Performer RPM cylinder heads
Part #8556
Installation Instructions
Please study these instructions, and the cylinder head instructions, carefully before installing your new Head Bolt Kit. If you
have any questions or problems, do not hesitate to contact our Technical Hotline at: 1-800-416-8628.
Application:
This head bolt kit is intended for use on the Edelbrock Performer RPM Pontiac cylinder heads #6056, #6057, and #6058.
High quality 1/2" diameter bolts are manufactured by ARP to the highest standards of performance. Hardened and parallel-
ground washers are included and must be used with each head bolt. This head bolt kit is required to install Edelbrock
Pontiac cylinder heads. These heads require head bolts similar to those for a Ram Air IV head, except several of the bolt
boss heights have been increased to enhance the performance potential of the cylinder heads.
Kit Contents:
Qty
. Bolt length Boss location (see Figure 1)
4 3.00" A
4 4.00" B
2 3.75" C
2 4.25" D
4 4.15" E
4 2.25" F
20 Hardened washers
Figure 1- Head Bolt Boss locations
Note: Torque upper row of bolts to 105 ft./lbs., torque lower row of bolts to 95 ft./lbs.
in three even increments. Coat threads, washers, and underside of bolt heads with
motor oil for accurate torque readings. Start in center and work out towards ends. Re-
torque all head bolts after initial warm-up and cool-down.
A
A
B
B
C
D
E
E
F
F
©2009 Edelbrock Corporation
Part #8556
Brochure #63-8556
Rev. 7/09 - AJ/mc
  • Page 1 1

Edelbrock E-Series Cylinder Head Bolt Kit #85562 for Pontiac w/ heads Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI