13
Controls, Connectors, and Indicators
ID Name Description
8 Firmware
Page 34
9 POH When using an HDBaseT™ Receiver that
complies with the Power-Over-HDBaseT
on the front panel to On by sliding it to the
right. Please remember that POH is a HDBa-
using a non-POH-compliant Receiver or not
using an HDBaseT Receiver at all, this switch
10 To switch between HDMI, DisplayPort™, DVI,
and VGA inputs, press and release this button.
and hold this button for 3 seconds or longer
until the function engages or disengages.
for more info.
11 HDBaseT™ Out Connect a CAT-5e or better cable, up to the
recommended length for a given resolution,
from this port to the HDBaseT™ In port of the
Receiver unit. This Switcher can send power to
the EXT-UHDA-HBTL-RX or another POH-
compatible Receiver over the CAT-5 cable, but
12 HDMI Out Use a Gefen HDMI cable to connect an HDMI
display to this port.
13 Audio Output
channels of audio de-embedded from the
HDMI Output signal, for use with outboard
audio cable from this port to the analog
connector.