Unika PD-1 is an advanced power conditioner designed to provide clean and reliable power to your audio equipment. With a total power capacity of 1800 watts, the PD-1 can handle even the most demanding setups. It features 8 rear-panel outlets, 3 front-panel outlets, and 1 front-panel unswitched outlet, giving you plenty of options for connecting your gear. The PD-1 also includes surge and spike protection to keep your equipment safe from power surges and other electrical hazards.
Unika PD-1 is an advanced power conditioner designed to provide clean and reliable power to your audio equipment. With a total power capacity of 1800 watts, the PD-1 can handle even the most demanding setups. It features 8 rear-panel outlets, 3 front-panel outlets, and 1 front-panel unswitched outlet, giving you plenty of options for connecting your gear. The PD-1 also includes surge and spike protection to keep your equipment safe from power surges and other electrical hazards.
POWER CONDITIONER
P R O F E S S I O N A L A U D I O
6F, No.168, Xin-Hu 2nd Rd.
Nei-Hu District, Taipei City. 11494.
Taiwan, Republic of China.
+886 2 27933017
+886 2 27928264
Unika Electronic Co., Ltd.
w w w . u n i k a . c o m . t w
PD Series
User Manual
Made in Taiwan
PD-1 / 2 / 3
PROFESSIONAL POWER DISTRIBUTION MODULE
VOLTAGE TIME CURRENT
UN SWI TCH ED POWER
I
O
TOTAL MAX 1 4.9A
O
T
R
S
E
S
S
E
E
R
T
P
RESET
HO UR
MI NUT E
TI ME SETU P
UN SWI TCH ED POWER
I
O
TOTAL MAX 1 4.9A
O
T
R
S
E
S
S
E
E
R
T
P
RESET
POWER D IST RIB UT ION M ODU LE
PROFESSIONAL POWER DISTRIBUTION MODULE
VOLTAGE TIME CURRENT
RE AR
LI GHT
FR ONT
LE D
HO UR
MI NUT E
UN SWI TCH ED POWER
I
O
TI ME SETU P
TOTAL MAX 1 4.9A
O
T
R
S
E
S
S
E
E
R
T
P
RESET
AC IN LI GH T
~12V 420m A
~120V 50/ 60Hz
15A
CH8/10A CH7/10A CH6/10A CH5/10A CH4/10A CH3/10A CH2/10A CH1/10A
TOTAL MAX 15A
Page 1
PD-1 / 2 / 3
We congratulate you on choosing UNiKA PD Series power conditioner. This series is
designed for easy use and incorporate the latest advances in power technology, along
with useful and innovative features. Please read all instructions carefully before
operating.
INTRODUCTION
1. Rack Mounting Ears - Two front panel mounting holes are provided on each
mounting ear.
2. Rear light ON/OFF switch for gooseneck lamp - This switch controls to turn ON
or turn OFF the rear light.
3. Front light On/OFF switch for 2 pull-out LED light pipes - This switch controls
to turn ON or turn OFF the front 2 pull-out LED light pipes.
4. Hour and Minute buttons for time set up - These buttons enable to set-up hour
and minute which are shown in the LCD screen.
5. Two front panel pull-out LED light pipes - These retractable LED light pipes
helps users to operate in a dark environment easily and more convenient.
6. LCD digital voltmeter/ammeters/system clock - This LCD indicates voltage,
time and current for users easily to control them properly.
7. Front panel resettable circuit breaker - This reset button is used to reset the
breaker.
8. Unswitched front panel convenience outlet - This outlet keeps power that is
always ON.
9. AC power illuminated switch - The switch is used to turn ON or turn OFF the 8
rear panel outlets.
10. Power Output (CH9~CH11)
FRONT PANEL
PROFESSIONAL POWER DISTRIBUTION MODULE
VOLTAGE TIME CURRE NT
UN SWI TCH ED POWER
I
O
TOTAL MAX 1 4.9 A
O
T
R
S
E
S
S
E
E
R
T
P
RESE T
HO UR
MI NUT E
TI ME SE TU P
UNiKA
UN SWI TCH ED POWER
I
O
TOTAL MAX 1 4.9 A
O
T
R
S
E
S
S
E
E
R
T
P
RESE T
POW ER D IST RIB UTI ON MO DUL E
UNiKA
PROFESSIONAL POWER DISTRIBUTION MODULE
VOLTAGE TIME CURRE NT
RE AR
LI GHT
FR ONT
LE D
HO UR
MI NUT E
UN SWI TCH ED POWER
I
O
TI ME SE TU P
TOTAL MAX 1 4.9 A
O
T
R
S
E
S
S
E
E
R
T
P
RESE T
UNiKA
3 51 2 6 957 184
1 97 1810
11. AC Power Cord - Plug this cable into a standard 110V or 220V wall outlet. Be sure
that the supplied voltage in your area matches the unit's required voltage. Never
plug your power conditioner into a wall outlet that does not match its required
voltage which helps to avoid serious damage may occurred on the unit.
12. XLR lamp connector - This is used to connect the detachable gooseneck lamp.
(The gooseneck lamp is an optional accessory up to customer's demand, the
standard product doesn't include this lamp.)
13. Power Output (CH1~CH8) - For CH6~CH8, 3 outlets with wall wart spacing.
REAR PANEL
FEATURES
All PD series models (PD-1/2/3)
8 rear panel outlets and 1 unswitched font panel convenience outlet.
3 outlets with wall wart spacing
Total power capacity of 1800 watts
Surge and spike protection
Rear XLR lamp connector for gooseneck lamp detachable
Front panel resettable circuit breaker and power illuminated switch
For PD-1
3 additional front panel outlets (total 11 switched outlets, 1 unswitched outlet)
For PD-2
LCD digital voltmeter/ammeters/system clock
Hour and Minute buttons for time set up
For PD-3
LCD digital voltmeter/ammeters/system clock
Hour and Minute buttons for time set up
2 front panel pull-out LED light pipes with front LED on/off switch
Rear light on/off switch for gooseneck lamp
Page 2
MAXIMUM LOAD
The eight circuit breaker protected outlets are rated at 15 amps total, which is equivalent
to 1800 watts at 120 volts. If the total load exceeds 15 amps, the circuit breaker will trip,
cutting off power to your rack. If this happens, reduce the load by unplugging one or
more units from the unit, then push the circuit breaker button in to reset it.
OPERATION
All the PD Series with the same rear panel as below:
PD-1 / 2 / 3
AC IN LIGHT
~12V 42 0mA
~120V 5 0/60H z
15A
CH8/10A CH7/10A CH6/10A CH5/10A CH4/10A CH3/10A CH2/10A CH1/10A
TOTAL MAX 15A
1311 12
LAMPS
The PD series power conditioner with easily pull-out LED light pipes (PD-3 only) and may
be aimed to provide the best illumination for your equipment. You should set the front rack
lights switch to the OFF position if not using the lights for an extended period of time.
AC POWER SWITCH
The PD series power conditioners have a master AC POWER switch for the rear outlets.
This switch glows when the unit is on.
WARNINGS
1. All operating instructions should be read before using this equipment.
2. To prevent the risk of electrical shock, do not remove the cover or the back. There are
no user serviceable parts inside.
3. Do not expose this unit to rain or moisture or to heat sources such as radiators,
stoves, or other items that generate excessive heat.
4. This unit should be cleaned only with a damp cloth. Do not get moisture inside the unit.
5. When moving this equipment, it should be placed in its original carton and packing, to
reduce the risk of damage in transit.
PD-1 / 2 / 3
PD
-
1
1800watts
15amps
PD
-
2
Total Power Capacity
Maximum Output Current
Power Outlets
Circuit Breaker
Protection Circuit
Construction
Power Switch
Dimensions (H×W×D)
Weight
Rack Space
XLR Connector
1800watts
15amps
44 x 483 x 284mm
3.3kg
1U
X
Metering
44 x 483 x 284mm
3.8kg
1U
LCD Digital Display
Input Voltage, Current & Time
Front Panel Resettable Breaker
Surge & Spike Protection
Steel Chassis
Front Panel Resettable Breaker
Surge & Spike Protection
Steel Chassis
Front Panel Power On/Off
Illuminated Switch
Front Panel Power On/Off
Illuminated Switch
PD
-
3
1800watts
15amps
44 x 483 x 284mm
3.9kg
1U
Front Panel Resettable Breaker
Surge & Spike Protection
Steel Chassis
Rear Rack Lamp
12V/420mA Max
(Lamp Not Included)
Rear Rack Lamp
12V/420mA Max
(Lamp Not Included)
Rear Rack Lamp
12V/420mA Max
(Lamp Not Included)
8 Rear Panel Outlets,
3 Front Panel Outlets and
1 Front Panel Unswitched Outlet
8 Rear Panel Outlets and
1 Front Panel Unswitched Outlet
8 Rear Panel Outlets and
1 Front Panel Unswitched Outlet
Front Panel Power On/Off
Rear Light On/Off Switch and
Front LED On/Off Switch
Illuminated Switch,
SPECIFICATIONS
Filtering Advanced Power FilteringAdvanced Power Filtering Advanced Power Filtering
LCD Digital Display
Input Voltage, Current & Time
Light Pipes
XX 2 Front Pull-Out, Shock Mounted
-
1
-
2
-
3
-
4
Unika PD-1 Owner's manual
- Type
- Owner's manual
Unika PD-1 is an advanced power conditioner designed to provide clean and reliable power to your audio equipment. With a total power capacity of 1800 watts, the PD-1 can handle even the most demanding setups. It features 8 rear-panel outlets, 3 front-panel outlets, and 1 front-panel unswitched outlet, giving you plenty of options for connecting your gear. The PD-1 also includes surge and spike protection to keep your equipment safe from power surges and other electrical hazards.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Citronic CPD-8C User manual
-
PylePro PCO800 Owner's manual
-
Trojan Tour 400 Owner's manual
-
Nady Systems PCL-815 User manual
-
ETA Systems ETA-ECS3 User manual
-
-
-
Samson Stereo Amplifier PB9 User manual
-
ETA Systems ETA-S20RT User manual
-