RIDGID PC-1375 Blade Change Operating instructions

RIDGID
Brand
RIDGID
Model
PC-1375 Blade Change
Type
Operating instructions
Blade Installation
1. Place new blade into cutter so that the roller enters the
blade slot.
Figure 3
2. Reinstall “PC-1375” half of the handle.
3. Reinstall and tighten the three mounting screws.
4. Line up the lower handle hole and blade hole. Reinstall
the blade pin and the retaining ring.
Figure 4
PC-1375 Blade Change Instructions
Ridge Tool Co., Elyria, Ohio, U.S.A.
10/07
Printed in U.S.A. 010-338-222.10
Rev. A
PC-1375 Plastic Pipe and Tubing
Cutter Blade Change Instructions
WARNING
• Always wear safety goggles.
• Blade is sharp. Handle with care.
Blade Removal
1. Unlatch the handles so that they are fully open.
2. Remove retaining ring from the blade pin and remove
the blade pin
3. Lay the cutter on a flat surface with the “PC-1375” logo
facing up and remove the screws.
Figure 1
4. Remove the “PC-1375” half of the cutter handle.
5. Remove the blade.
Figure 2 – Blade Removal
Unlatch
Retaining Ring
and Pin
Screws
Install Blade
Over Roller
Unlatch
Retaining Ring
and Pin
Screws
  • Page 1 1

RIDGID PC-1375 Blade Change Operating instructions

RIDGID
Brand
RIDGID
Model
PC-1375 Blade Change
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents