Manual release kit for LIBRA garage door opener
Installation manual
SECTIONAL doors
1) Open the door wide.
2) Place the thin steel cable with end-ball in the pulling trolley (Fig. A).
3) Thread the steel cable into the rubber sheath and insert it in the eyelets of the anchoring door bracket (Fig. B).
4) Fasten the steel cable directly to the lock catch (Fig. C1) or to the door’s handle by piercing it (Fig. C2).
Make sure that the steel cable’s tension is suitable to operate the release when twisting the handle.
5) In case, cut the extra cable away.
Warning:
Perform the manual release operation only when the door is not moving.
MLIR07
Proteco S.r.l. Via Neive, 77 - 12050 CASTAGNITO (CN) ITALY
Tel. +39 0173 210111 - Fax +39 0173 210199 - www.mygateautomation.com
Sblocco manuale da esterno per aprigarage LIBRA
Manuale di installazione
Fig. A Fig. B
Fig. C1 Fig. C2
MLIR07
Manual release kit for LIBRA garage door opener
Installation manual
Manual release kit for LIBRA garage door opener
Installation manual
COUNTERWEIGHTED doors (with adaptor arm PARC01)
1) Open the door wide.
2) Place the thin steel cable with end-ball in the pulling trolley (Fig. A).
3) Cut the anchoring door bracket (not used in case of counterweights balance door with adaptor arm) as shown in Fig. B and fix the
bracket on the door beside the adapter arm.
4) Thread the steel cable into the rubber sheath and insert it in the eyelets of the anchoring door bracket (Fig. C).
5) Fasten the steel cable directly to the lock catch (Fig. D1) or to the door’s handle by piercing it (Fig. D2).
Make sure that the steel cable’s tension is suitable to operate the release when twisting the handle.
6) In case, cut the extra cable away.
Warning:
Perform the manual release operation only when the door is not moving.
MLIR07
Sblocco manuale da esterno per aprigarage LIBRA
Manuale di installazione
Fig. A Fig. B
Fig. C Fig. D1 Fig. D2
MLIR07
Manual release kit for LIBRA garage door opener
Installation manual
-
1
-
2
