A
second &or, seating and column position may be
programmed by repeating the above steps and pressing
button
2.
Each time a memory button is pressed, a single
beep will sound through the radio. Each time button
1
or
2
is pressed, the memory positions will
be
recalled. At the
factory, the exit position is preset with the steering wheel
full
up and the seat
full
back. However,
two
personalized
exit positions can
be
set by first recalling the driving
position (Driver
“1”
or
“2”),
positioning the wheel and
seat in the desired exit positions and then pressing the
MEMORY
SET
and, within five seconds, pressing the
EXIT
button. The exit position for
either
previously set
driver can
be
recalled by pressing the
EXIT
button.
Heated Seat (Option)
This option is
only
available if your vehicle is equipped
with the power lumbar control feature.
The front seat controls are
located in the center
console. The rear seat
controls, for the outboard
positions only, are located
on the rear door (note that
only the outboard positions
in the rear seats are heated).
Push
the button once
for
a
high setting,
twice
for
a
low
setting, and a third time to turn
off
the heated seat. The
LO
setting warms the seatback and cushion until the seat
approximates body temperature. The
HI
setting heats the
seat to a slightly higher temperature.
The heated seats can only be used when the ignition is
turned on. The heating elements in the seats
automatically
turn
off
when the vehicle’s ignition is
turned off.
Reclining Front Seatbacks
The power controls
are located on the
outboard side
of
each
front seat. Press the
top
of the control
forward or rearward
to adjust the seatback
angle. Push up or
down to adjust the
headrest and
shoulder belt.