Extron PS 18DR User manual

PS 18DR Installation Guide

The Extron PS 18DR DIN Rail Adapter enables a user to mount an eighth-rack Extron device

to a standard 35 mm DIN rail, with a depth of 7.5 mm or greater. The adapter includes a DIN

rail clip attached to a mounting plate, and the necessary screws to mount the device.

35 mm DIN Rail

DIN Rail

Mounting Clip

Mounting Plate

Vertical Mounting

Side View

Attach the 1/8 rack Extron

device (horizontally or vertically)

to the mounting plate with the

(2) 4-40 mounting screws.

Hook the spring side of

the DIN rail clip under the

bottom of the DIN rail and

pull up on the spring.

Align the top

clip ﬂush with the

rail and release.

NOTE: To remove the PS 18DR from the rack, push upward on the clip, pull the top of the

clip off the rail, and move the entire clip down, away from the rail.

PS 18DR Installation Guide, Continued

Horizontal Mounting

35 mm DIN Rail

DIN Rail

Mounting Clip

Mounting Plate

NOTE: The eighth-rack desktop power supply can be mounted on the rack adapter either

horizontally or vertically. If mounted vertically, clip on the DIN rail with the power cable

toward the floor.

68-3218-50 Rev. B

05 18