JUNG F-ANT Operating instructions

Type
Operating instructions

JUNG F-ANT

The JUNG F-ANT is a radio antenna designed to supplement the integrated antenna of the JUNG RMD radio receiver in cases where the installation conditions are unfavourable, such as in a metallic distribution box. The antenna is 17 cm long and has a 2.7 m cable with an SMB connector. It is intended to be placed on an electrically conductive surface for optimal reception, and should be positioned at a 90° angle to the surface.

JUNG F-ANT

The JUNG F-ANT is a radio antenna designed to supplement the integrated antenna of the JUNG RMD radio receiver in cases where the installation conditions are unfavourable, such as in a metallic distribution box. The antenna is 17 cm long and has a 2.7 m cable with an SMB connector. It is intended to be placed on an electrically conductive surface for optimal reception, and should be positioned at a 90° angle to the surface.

Radio antenna
Radio Management
Radio antenna
Art.-No.: F-ANT
Operationsmanual
1 Safety instructions
Electrical equipment may only be installed and fitted by electrically skilled persons.
Failure to observe the instructions may cause damage to the device and result in fire and
other hazards.
The radio antenna including the antenna cable are not electrically isolated. Isolate the
antenna and antenna cable from mains voltage in a reliable manner using suitable
isolation measures.
To ensure adequate contact protection, operate device only with the slide in use.
These instructions are an integral part of the product, and must remain with the end
customer.
2 Device components
picture 1
(1) Antenna
(2) Magnetic base
(3) Antenna connector
3 Function
Intended use
The radio antenna supplements the integrated antenna of the radio receiver RMD in case of
unfavourable installation conditions, e.g. a metallic distribution box.
1/4
82553113
J:0082553113
30.07.2010
4 Information for qualified electricians
4.1 Fitting and electrical connection
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
Before carrying out work on the device or load, disengage all the
corresponding circuit breakers. Cover up live parts in the working environment.
i To ensure optimal reception, place antenna on an electrically conductive surface;
50×50 cm is ideal. The antenna should be as close as possible to a 90° angle relative to
the surface.
Routing the antenna in front of the panel cover of the distributor
picture 2
o Insert the antenna connector (3) into the SMB socket (4) of the radio receiver RMD (5)
(picture 2).
o Route the antenna out of the distributor providing reliable isolation.
2/4
82553113
J:0082553113
30.07.2010
Radio Management
Radio antenna
Routing the antenna in behind the panel cover of the distributor
picture 3
o Unlock the black slide (6) by pulling up on the bow and pull out slide (picture 3).
o Insert the antenna connector (3) into the SMB socket (4) of the radio receiver RMD (5).
o Re-insert the black slide until it engages noticeably.
i The slide fixes the cable in place and ensures that the maximum installation height in the
distributor is maintained.
5 Appendix
5.1 Technical data
Antenna length 17 cm
Cable length 2.7 m
Connection SMB connector
3/4
82553113
J:0082553113
30.07.2010
Radio Management
Radio antenna
5.2 Warranty
We reserve the right to make technical and formal changes to the product in the interest of
technical progress.
We provide a warranty as provided for by law.
Please send the unit postage-free with a description of the defect to our central customer
service office:
ALBRECHT JUNG GMBH & CO. KG
Service Center
Kupferstr. 17-19
D-44532 Lünen
Service-Line: +49 (0) 23 55 . 80 65 51
Telefax: +49 (0) 23 55 . 80 61 89
General equipment
Service-Line: +49 (0) 23 55 . 80 65 55
Telefax: +49 (0) 23 55 . 80 62 55
KNX equipment
Service-Line: +49 (0) 23 55 . 80 65 56
Telefax: +49 (0) 23 55 . 80 62 55
The Œ symbol is a free trade symbol, which is solely intended for the authorities and does not
guarantee any properties.
ALBRECHT JUNG GMBH & CO. KG
Volmestraße 1
D-58579 Schalksmühle
Telefon: +49.23 55.8 06-0
Telefax: +49.23 55.8 06-1 89
Internet: www.jung.de
www.jung-katalog.de
4/4
82553113
J:0082553113
30.07.2010
Radio Management
Radio antenna
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

JUNG F-ANT Operating instructions

Type
Operating instructions

JUNG F-ANT

The JUNG F-ANT is a radio antenna designed to supplement the integrated antenna of the JUNG RMD radio receiver in cases where the installation conditions are unfavourable, such as in a metallic distribution box. The antenna is 17 cm long and has a 2.7 m cable with an SMB connector. It is intended to be placed on an electrically conductive surface for optimal reception, and should be positioned at a 90° angle to the surface.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI