User Instructions

9/14

VF FLURRY

©2013 ADJ Products, LLC all rights reserved. Information,

specications, diagrams, images, and instructions herein are

subject to change without notice. ADJ Products, LLC logo and

identifying product names and numbers herein are trademarks

of ADJ Products, LLC. Copyright protection claimed includes all

forms and matters of copyrightable materials and information

ADJ Products, LLC and all aliated companies hereby dis-

claim any and all liabilities for property, equipment, building,

and electrical damages, injuries to any persons, and direct or

indirect economic loss associated with the use or reliance of

any information contained within this document, and/or as a

result of the improper, unsafe, unsucient and negligent as-

sembly, installation, rigging, and operation of this product.

Europe Energy Saving Notice

Energy Saving Matters (EuP 2009/125/EC)

Saving electric energy is a key to help protecting the enviroment.

Be sure that all the snow uid is kept inside the uid reservoir

• Be sure that the local power outlet match that or the required

voltage for your snow machine

• Do not remove the top cover under any conditions. There are no

user serviceable parts inside

• Disconnect the unit’s main power when left unused for long peri-

ods of time

• Never connect this unit to a dimmer pack

• Do not attempt to operate this unit, if it becomes damaged in anyway

• Never operate this unit when it’s cover is removed

• Disconnect from main power before making any type of connection

• Never block the ventilation holes. Always be sure to mount this

unit in an area that will allow proper ventilation. Allow about 6”

(15cm) between this device and a wall

• This unit is intended for indoor use only, use of this product out-

doors voids all warranties

• Always mount this unit in a safe and stable matter

• Please route your power cord out of the way of foot trac. Power

cords should be routed so they are not likely to be walked on,

pinched by items placed upon or against them

exhibits a marked change in performance.

VF Flurry Safety Precautions

ADJ Products, LLC - VF Flurry Instruction Manual Page 2 ADJ Products, LLC - VF Flurry Instruction Manual Page 3

Introduction: Congratulations, you have just purchased the VF Flurry

snow machine. The VF Flurry snow machine has been designed to

perform reliably for years when the guidelines in this booklet are fol-

lowed. Please read and understand the instructions in this manual

carefully and thoroughly before attempting to operate this unit. These

instructions contain important information regarding safety during use

and maintenance.

Pacic Standard Time.

Voice: (800) 322-6337

Fax: (323) 582-2941

E-mail: [email protected]

To purchase parts online visit http://parts.americandj.com

Warning! To prevent or reduce the risk of electrical shock or re, do

not expose this unit to rain or moisture.

Caution! There are no user serviceable parts inside this unit. Do not

attempt any repairs yourself, doing so will void your manufactures war-

ranty. In the unlikely event your unit may require service please contact

VF Flurry Introduction

VF Flurry Description VF Flurry Operating Instructions

The new VF Flurry snow machine features a snow juice level sensor.

When the snow juice level reaches a low level, a bult-in sensor inside

the reservoir will automatically shut off the pump. This will greatly

expand the life of the pump.

This unit includes a switch located on the rear panel that allows

you to control the speed of the air pump located inside the unit.

This switch controls the size of the flakes that are produced by the

machine. In the max position the air flow will be low, producing larger

flakes. In the minimum position the air flow will be higher produc-

ing smaller flakes. The snow output volume is controlled using the

snow juice is created equal.

let. The red LED (liquid) will glow when there is enough snow fluid in

the tank. The green LED will glow when the snow machine is in use.

To emit snow, adjust the OUTPUT VOLUME knob to your desired and

time. If the green LED. is on and snow does not come out after hold-

ing the button down for 30 seconds, check the fluid tank and hose to

ADJ Products, LLC - VF Flurry Instruction Manual Page 4 ADJ Products, LLC - VF Flurry Instruction Manual Page 5

2. Be sure to remove all the packing material especially around the

nozzle/sock.

3. Set the snow machine on a flat dry surface. Locate the included

bracket from the package and install it using the supplied hard-

ware to the side casing. Note: The bracket is an optional accesso-

ry and may not be used if desired, however if you intend to sus-

pend the unit from truss the bracket must be used.

4. Remove the fluid reservoir and fill it with American DJ® brand

snow juice only and replace the reservoir.

5. Place the feeder tube with the filter deep inside the reservoir and

a small to large snow output.

8. Plug the unit in to a matching power supply. Switch on the main

power located on the rear of the unit.

9. Follow the operating instructions on the next page for proper

operation.

ADJ Products, LLC - VF Flurry - Instruction Manual Page 6

VF Flurry Warranty

MANUFACTURER’S LIMITED WARRANTY

VF Flurry Warranty Registration

ADJ Products, LLC - VF Flurry - Instruction Manual Page 7

ADJ Products, LLC - VF Flurry - Instruction Manual Page 8 ADJ Products, LLC - VF Flurry - Instruction Manual Page 9

VF Flurry Notes VF Flurry Notes

VF Flurry Specifications

ADJ Products, LLC - VF Flurry - Instruction Manual Page 10