Philips HP4624/00 User manual

Category
Hair stylers
Type
User manual
6
Introduction
Congratulations on your purchase and welcome to Philips! To fully benet
from the support that Philips offers, register your product at www.philips.
com/welcome.
This new Philips Salon Airstylist has been specially designed to give
beautiful styling results in a quick and easy way.
General description (Fig. 1)
A Bristle retraction knob
B Retractable bristle brush
C Release button
D Airow slide switch
O = off
I = gentle warm airow for easy styling
II = stronger and warmer airow for fast styling
E Air inlet grille
F Hanging loop
G Shaping brush
Important
Read this user manual carefully before you use the appliance and save it
for future reference.
Danger
Keep the appliance away from water. Do not use it near or over
water contained in baths, washbasins, sinks etc. When you use the
appliance in a bathroom, unplug it after use. The proximity of water
presents a risk, even when the appliance is switched off.
Always make sure that the attachments are completely dry - on the
inside as well as on the outside - before you t them onto the styler.
Do not insert metal objects into the air inlet grille to avoid electric
shock.
Warning
Check if the voltage indicated on the appliance corresponds to the
local mains voltage before you connect the appliance.
-
-
-
-
-
-
-
ENGLISH
Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the mains cord or the appliance itself is damaged.
If the mains cord is damaged, you must have it replaced by Philips, a
service centre authorised by Philips or similarly qualied persons in
order to avoid a hazard.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
Never leave the appliance unattended when it is plugged in.
Caution
For additional protection, we advise you to install a residual current
device (RCD) in the electrical circuit that supplies the bathroom. This
RCD must have a rated residual operating current not higher than
30mA. Ask your installer for advice.
The attachments become hot during use. Prevent contact with the
skin.
Never block the air inlet grille.
If the appliance overheats, it switches off automatically. Unplug the
appliance and let it cool down for a few minutes. Before you switch
on the appliance again, check the grille to make sure it is not blocked
by uff, hair, etc.
Always unplug the appliance after use.
Do not use the appliance on articial hair.
Do not use the appliance for any other purpose than intended.
Wait until the appliance has cooled down before you store it.
Always switch off the appliance before you put it down, even if it is
only for a moment.
Do not wind the mains cord round the appliance.
Never use any accessories or parts from other manufacturers or that
Philips does not specically recommend. If you use such accessories
or parts, your guarantee becomes invalid.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
ENGLISH 7
Keep the attachments clean and free of dust, dirt and styling products
such as mousse, spray and gel.
Electromagnetic elds (EMF)
This Philips appliance complies with all standards regarding
electromagnetic elds (EMF). If handled properly and according to the
instructions in this user manual, the appliance is safe to use based on
scientic evidence available today.
Preparing for use
Hair
1 The Salon Airstylist is most effective when the hair is slightly damp.
Slightly dampen your hair if it is dry.
Never use the appliance on wet hair.
2 Comb or brush the hair so that it is untangled and smooth.
3 Use a comb to divide the hair into locks. Do not put too much hair
in one lock.
Connecting and disconnecting attachments
Do not insert the mains plug into the wall socket until after you have
connected the attachment.
1 To connect the attachment to the styler, align the arrows on the
attachment with the arrows on the styler and press the attachment
home (‘click’) (Fig. 2).
2 To remove the attachment from the appliance, press the release
button (1) and pull the attachment off the styler (2). (Fig. 3)
Using the appliance
Making curls
We advise you to perform a curl test to determine how long the brush
should be held in your hair to achieve a good result. Start with 8 to 10
-
ENGLISH8
seconds. You may have to hold the brush in your hair longer for tighter
curls. Less tight curls require less than 8 seconds.
1 Snap the retractable bristle brush onto the appliance (see chapter
‘Preparing for use’).
2 Divide the hair into locks.
3 Take a lock of hair and wind it round the brush. Make sure you
wind the end of the lock in the required direction.
Do not wind too much hair round the brush at a time.
Do not wind a lock of hair more than twice round the brush.
The thinner the lock of hair, the tighter the curl becomes.
Make sure the lock of hair is in contact with the barrel of the brush.
Tip: If you wind the hair at right angles to the scalp, you give your hair
optimum lift and volume.
4 Settheairowslideswitchtothedesiredsettingtoswitchonthe
appliance: (Fig. 4)
I: gentle warm airow for easy styling
II: stronger and warmer airow for fast styling
5 Keep the brush in your hair until the hair is warm to the touch.
6 SettheairowslideswitchtoOtoswitchofftheappliance.
7 To remove the brush from your hair, press the bristle retraction
knob (1) and turn the knob anticlockwise (2). (Fig. 5)
8 Letthecurlscooldownbeforeyoucomb,brushornger-comb
thehairtonishyourstyle.
9 Whenyouhavenishedcurling,switchofftheapplianceand
remove the brush (see chapter ‘Preparing for use’).
Shaping your hair
1 Snap the shaping brush onto the appliance (see chapter ‘Preparing
for use’).
2 Insert the brush pins into your hair until they touch your scalp.
-
-
-
-
-
-
ENGLISH 9
3 Settheairowslideswitchtothedesiredsettingtoswitchonthe
appliance: (Fig. 4)
I: gentle warm airow for easy styling
II: stronger and warmer airow for fast styling
4 Lift a lock of hair at the roots and move the brush along the lock
from root to tip. Work from one side of the head all round the
scalp.
This technique tames stray ends and helps to promote shine and softness.
5 Whenyouhavenishedshaping,switchofftheapplianceand
remove the brush (see chapter ‘Preparing for use’).
Cleaning
Never immerse the appliance in water or any other liquid, nor rinse it
under the tap.
1 Switch off the appliance and unplug it.
2 Put the appliance in a safe place and let it cool down.
3 Clean the appliance with a small brush or a dry cloth.
4 Remove any attachments from the appliance before you clean the
attachment.
5 Clean the attachments with a moist cloth or rinse them under the
tap.
6 Dry the attachments before you use or store them.
Storage
Do not wind the mains cord round the appliance.
1 Switch off the appliance and unplug it.
2 Put the appliance in a safe place and let it cool down.
3 You can store the appliance by hanging it from its hanging
loop (Fig. 6).
-
-
ENGLISH10
Environment
Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an ofcial collection point for
recycling. By doing this, you help to preserve the environment (Fig. 7).
Guarantee & service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care
Centre in your country (you nd its phone number in the worldwide
guarantee leaet). If there is no Customer Care Centre in your country,
go to your local Philips dealer or contact the Service Department of
Philips Domestic Appliances and Personal Care BV.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Customer Care Centre in your
country.
Problem Possible cause Solution
The
appliance
does not
work.
There is a power
failure or the socket
to which the
appliance is
connected is not live.
Check if the power supply
works. If it does, plug in another
appliance to check whether the
socket is live.
You have not
switched on the
appliance.
Set the airow slide switch to
the desired setting to switch on
the appliance.
The appliance has
overheated and
switched itself off.
Before you switch on the
appliance again, check the grille
to make sure it is not blocked by
uff, hair, etc.
-
ENGLISH 11
Problem Possible cause Solution
The appliance is not
suitable for the
voltage to which it is
connected.
Make sure that the voltage
indicated on the appliance
corresponds to the local mains
voltage.
The mains cord is
damaged
If the mains cord is damaged,
you must have it replaced by
Philips, a service centre
authorised by Philips or similarly
qualied persons in order to
avoid a hazard.
ENGLISH12
www.philips.com
u
4222.002.6310.3
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56
  • Page 57 57
  • Page 58 58
  • Page 59 59
  • Page 60 60
  • Page 61 61
  • Page 62 62
  • Page 63 63
  • Page 64 64

Philips HP4624/00 User manual

Category
Hair stylers
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI