INSTALLATION INSTRUCTIONS
Web: www.penn-elcom.com E-Mail: [email protected]
STEP 1: STEP 2: STEP 3:
Place the template where you want the drawer,
ensuring it’s at the front lip of the desk and secure
using tape.
Identify your model number from the four options. Using a pen, mark the four screw locations on the
template for your model.
If you have fitted with the desk upside down, close and lock the drawer before turning over.
BEFORE YOU START:
Prepare the four wood screws and drill hole template included with your kit. You’ll also need a pen. If you can turn your table upside down, fixing will be
easier and safer. If it is not possible to turn your desk over, assembly will be made easier with two people to hold and fit the unit.
STEP 4: STEP 5: STEP 6:
Using a bradawl or drill, make four small pilot holes at
each marked location and remove the template.
Place the drawer into position over the pilot holes. Screw firmly into place.
SCAN TO WATCH
INSTALLATION VIDEO
/
