Ortech OD-HSB201 User manual

Brand: Ortech

Model: OD-HSB201

Type: User manual

Ortech OD-HSB201 is an LED hardscape light designed for outdoor use. It operates on a safe low voltage range of 10V-14V AC/DC, making it ideal for illuminating pathways, patios, and other outdoor areas. Installation requires basic electrical knowledge and should be carried out by a qualified electrician. The fixture's durable construction and weather-resistant design ensure longevity and reliability in various outdoor conditions.

WARNING

LED Landscape Lighting — Hardscape Lights

MODEL OD-HSB201

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.

Electrical products can cause death or injury, or damage to property.

If in any doubt about the installation or use of this product, consult a competent electrician.

INSTALLATION GUIDE

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY

A QUALIFIED ELECTRICIAN.

1. This LED Hardscape light is intended for installation in accordance with the National Electric Code

(NEC) and local code specifications

2. DO NOT use this LED Hardscape Light other than its intended purpose

3. LED Hardscape Light can only be installed by a qualified electrician

4. The operating voltage range is 10V-14V AC/DC

Instruction Manual

1-888-543-6473

1-888-541-6474

13376 Comber Way

Surrey BC V3W 5V9

[email protected]

www.ortechindustries.com

375 Admiral Blvd

Mississauga, ON L5T 2N1

CAUTION

Application Notice

TO REDUCE THE RISK OF ELECTRIC SHOCK, OR INJURY TO PERSONS, READ THE INSTRUCTIONS BELOW:

1. Make sure the main power supply is turned OFF

2. Install the fixtures at least 10 feet (3.05m) or more from a pool, spa, or fountain

3. All parts MUST be used as indicated in this instruction manual. DO NOT substitute any parts, leave parts out, or use any worn out or

broken parts. Failure to follow the instructions could invalidate the UL listing of this fixture

4. Use approved / listed wire connection devices suitable for the applications

Materials

Please make sure the following items

are included when opening the box:

Fixture Bracket Instruction

Manual

Spare part

(2 setsP)

Installation in Brick or Masonry Wall

1. Turn OFF the supply power

2. Determine the desired location for each fixture.

Mark the location of the two screw holes and drill the holes for

the plastic anchors with an appropriate drill bit for the material

you are drilling into.

Place the plastic anchors in the holes

3. Put stainless steel mounting bracket and fixture in between layers

of hardscape material. Screw the 2 screws into the anchors

through the holes on the bracket, securing the fixture

4. Route the fixture wire through the wall to the main low voltage

supply cable using standard masonry procedures

5. Connect fixture wire to LOW VOLTAGE power supply

Installation in Brick or Hardscape Wall

(most common use)

Ortech OD-HSB201 User manual

Ortech OD-HSB201 User manual

Ortech OD-HSB201 User manual

Other documents