Jumper 2.4GHz ELRS AION-RX-MINI User manual

Hello! I've reviewed the user manual for the Jumper AION-RX-MINI telemetry receiver. This document provides essential instructions on setting up the device, including the binding process, failsafe settings, and key specifications. The receiver supports ELRS 2.4 mode, has a range of over 5KM and supports 16 channels. I'm here to assist you with any questions you may have about this device.
What is the binding procedure for the receiver?

What happens if the receiver is not bound within 20 seconds?

How to set failsafe for the receiver?

Antenna

Thank you for purchasing Jumper AION-RX-MINI full duplex telemetry receiver. In order to fully enjoy the benefits of

this system please read the instruction manual carefully and set up the device as described below.

Introduction

Overview

Specifications

Dimension: 17.2*8.8*4.3mm (L x W x H)

Weight: 1.1g

Number of Channels: 16Ch

Operating Voltage Range: 3.5V~6V

Operating Current: 60mA@5V

Operating Range: Full range

Distance: ＞5KM

Compatibility: radios in ELRS 2.4 mode

Binding is the process of uniquely associating receiver to a transmitter/transmitter RF module . A transmitter internal

or external RF module can be bound to multiple receivers (not to be used simultaneously).A receiver can only be

bound to one RF module.Follow the steps below to finish the binding procedure.

1.Put the transmitter/transmitter RF module into binding mode

2.Power on the receiver, the receiver's green light will flash and the receiver is in binding mode. Bind in the radio, the

receiver's green light will be always on, then the binding is completed.

If the receiver is not bound in 20 seconds after power-on, the receiver will get into Wifi firmware updating mode, the

green light will flash at the same time.

Binding Procedure

Failsafe is a useful feature which is for a preset channel output position whenever control signal is lost for a period.

Follow the steps to set Failsafe for channels necessary :

Failsafe for receiver supporting ELRS RF mode setting can be set via radio interface, which support no pulse, hold and

custom three modes for each channel.radio go to: MODEL SETUP/Internal RF/Failsafe.

Failsafe

Note: Failsafe setting via transmitter for channel output position just for ELRS RF

mode, and Failsafe setting via transmitter has higher priority to setting via receiver.

A reasonable Failsafe setting can decrease falling risk and damage.

www.jumper-rc.com

Jumper 2.4GHz ELRS AION-RX-MINI Manual

Front

Back

BOOT0

LED

VCC

GND

9.8

16.2