2. LECTRIC eBIKES
  3. Electric Bike Rack Adapter Bar
Electric Bike Rack Adapter Bar

LECTRIC eBIKES Electric Bike Rack Adapter Bar User guide

  • Hello! I've reviewed the Bike Adapter Bar user manual and can assist you with questions about its installation process and features. This document outlines how to properly and safely use the bar to create a suitable top tube for your bike and securely mount it onto a platform hitch rack. It also provides instructions for adjusting length and locking gates to ensure safe transport of your bike.
  • Can this adapter bar be used with a trunk rack?
    What is the length release button for?
    What should be done after placing the adapter bar on the bike?
STEP 1
Push the gate release buttons
and rotate gates open.
STEP 2
Push the leangth release button
and pull “seat post” side out.
How to correctly install your bike adapter bar. This bar creates a
top tube for bikes, allowing the bike to be securely mounted on
most platform mounted hitch rack systems. This bar is not to be
used with a trunk rack, or hanging style hitch rack.
LENGTH RELEASE BUTTON
GATE RELEASE BUTTONS
SEAT POST
SIDE
HANDLEBAR STEM
SIDE
BIKE ADAPTER BAR
STEP 3
Adjust length of the Bike Adapter
Bar and place large loop end around
the handlebar stem (or headset) and
small loop end around the seat post.
STEP 4
Rotate the gates so they “CLICK”
into the locked position. Installation
is now complete and ready to mount
your bike on the rack.
To remove the Bike Adapter Bar,
reverse the steps above.
CAUTION: Always double check to
make sure the Bike Adapter Bar is
correctly installed on the bike and
that the bike is securely attached to
the rack before driving your vehicle.
LECTRIC EBIKES WARRANTY POLICY
Lectric eBikes | 2311 W. Utopia Rd. Phoenix, AZ 85027 | Part: 226-00355-A001
[email protected] | (602) 715-0907 | Customer Service: 9am-5pm MST, Mon-Fri | www.lectricebikes.com
lectricebikes.com/warranty
DO'S AND DON’TS
/