R4SFL STEAM MOP
INSTRUCTION MANUAL
w w w . v y t r o n i x . c o m
CAUTION
The appliance emits very
hot steam to sanitize the
area of use. This means
that the steam head,
Microfiber Pad and Carpet
Glide get very hot during
use. Care should be taken
when using this appliance.
DO NOT touch them
during use except in the
approved manner as
outlined in this manual.
IMPORTANT
Be sure to read ALL
instructions and warnings
before using your appliance.
WARNING
Risk of electrical
shock: Be sure to read
and follow all instruct-
tions and warnings.
SAVE THESE
INSTRUCTIONS:
For household use only.
Any other use of this
appliance will void the
manufacturer’s warranty.
Basic precautions should be observed when using
an electrical appliance, including the following:
1. Do not direct steam at people, animals,
electrical appliances or electrical
outlets
2. Do not expose to rain.
3. Store indoors.
4. Unplug from outlet when not in use and
before conducting service
maintenance or trouble-shooting.
5. Do not leave the appliance unattended.
6. Do not leave the appliance connected
to an electrical outlet when not in use.
7. Do not service the appliance when it
is plugged in.
8. Do not use with damaged cord or plug.
9. Do not use your appliance if it has
been dropped, damaged, left
outdoors or dropped into water.
10. Do not handle the appliance with
wet hands.
11. Do not pull or carry by cord, use cord
as a handle, close door on cord, pull
cord around sharp corners or expose
cord to heated surfaces.
12. Do not unplug by pulling on cord.
13. Do not use on or near flammable or
toxic substances including, oil-based
paint thinner, gases, flammable dust or
other explosive or toxic vapours.
14. Do not allow to be used as a toy.
15. Do not use on leather, wax polished
furniture or floors, synthetic fabrics,
velvet or other delicate, steam-
sensitive materials.
16. Do not immerse in water or any other liquid.
17. Do not use for any purpose other
than described in this user manual.
18. Never put detergent or chemical
products into the appliance unless
they have been approved by
Vytronix Ltd, as this may damage it
or make it unsafe for use.
Important Safety Instructions
CAUTION
Always operate
appliance by gripping
the handle. Do not grip
by the pole.
CAUTION
Do not immerse your
appliance in water or any
other liquid.
IMPORTANT
Always ensure that your
appliance is UNPLUGGED
from the wall receptacle
prior to cleaning or
emptying the water tank.
Care & Maintenance
1. Turn your appliance off and unplug from the
electrical outlet.
2. Wrap power cord around cord hangers.
3. Leave the appliance for five minutes to cool
down after use before removing the
microfibre pad and emptying the water tank.
4. Never leave microfiber pad on the appliance
when you have finished using it. Always
remove the microfiber pad and wash in
warm water with a mild detergent. Never use
bleach or fabric softener when cleaning the
microfiber pad.
5. The microfibre pad can be washed in the
washing machine, we recommend leaving it
to hang dry or drying it on a radiator for
24hours to ensure it is fully dry and improve
the lifespan.
6. To improve the lifespan of your appliance
we recommend cleaning the water tank and
descaling it once a month or every four or
five uses, you can use a normal descaling
kit with water and run it through the steamer
until all the water has been used.
7. Always empty the water tank when you have
finished using your appliance.
19. Unplug by grasping the plug, not the cord.
20. Avoid using the appliance near children or
babies as this appliance gets very hot.
21. Contact vytronix customer support if you
experience any issues not detailed in the
troubleshooting guide.
22. Do not allow the unit to be repaired or
disassembled by anyone without proper
training to do so, doing so could cause a
fire or electrical shock or void warranty.
23. Do not puncture steam hose that is
exposed by the swivel steam head joint.
Operating Instructions
8. Wipe your appliance with a damp cloth to
clean. Never immerse the appliance in water
or any other liquid.
Helpful Hints:
1. Always use a vacuum or sweep before
sanitizing your floors.
2. The easiest way to use the machine is to tilt
the handle to a 45º angle and clean slowly 2-
3 yards at a time.
3. A good amount of steam passes through
the microfiber pad. We recommend that the
microfiber pad be changed when it becomes
oversaturated.
4. To remove stubborn stains from vinyl or
linoleum floors, pre-treat with a mild
detergent and some water before using the
steam mop.
Microfiber pads
How to Use Microfiber Pads
1. Please make sure that a completely dry pad is used.
2. As high temperature steam passes through a pad to contact the floor to
kill germs, molds, mites and to provide a certain amount of water
necessary for cleaning, it is natural that the pad gradually absorbs
moisture. After a certain length of time, the pad repels water and
becomes damp.
3. To keep the floor clean and dry, replace the pad when it is dirty.
4. Only remove the pad from unit when not in use and steam is not being
emitted.
How to Clean and Store
1. Hand wash or machine wash the microfiber pad in cold water on the
delicate cycle with a mild detergent. (Do not use a fabric softener)
2. Using a washing machine may shorten the lifespan of the pads.
3. We recommend air drying the microfiber pad for 24 hours.
Product Assembly &Parts
4
2
3
1
5
6
8
7
9
10
Base Assembly:
Insert screw as shown. Tighten using
a flat-head screwdriver. If screw turns
freely without "gripping" the insert
threads, apply additional pressure
when turning.
Floor Setting Indicator Light:
Ideal for ceramic, stone, tile and
other durable floors.
Perfect for sealed hardwood,
laminate, bamboo and other
delicate floors
11
12
13
11
12
13
7. Handle
8. Floor Setting Control
9. Floor Setting Indicator Light
10. Steam Power Switch
11. Storage Hook (rotates 360º)
12. Main Body Assembly Screw
13. Power Cord
Before Using Your steam mop
Be sure to read ALL instructions and warnings before using your steam mop.
WARNING
Your steam mop is designed to clean hard floor surfaces that will withstand high
heat. Do not use on unsealed wood or unglazed ceramic floors. On surfaces that
have been treated with wax or some no-wax floors, the sheen may be removed
by the heat and steam action. It is always recommended to test an isolated area
of the surface to be cleaned before proceeding. We also recommend that you
check the use and care instructions from the floor manufacturer.
Helpful Hint:
1. When heated, never leave the appliance in one spot on any surface for any
period of time.
2. Always empty water from water tank after use.
CAUTION
The appliance emits very hot steam to sanitize the area of use. This means that the
steam head, Microfiber Pad and Carpet Glide get very hot during use. Care should be
taken when using this appliance. DO NOT touch them during use except in the
approved manner as outlined in this manual.
Technical information:
Rated voltage: 220-240V
Rated frequency: 50Hz
Output power: 1600W (+5%,-10%)
Water tank capacity: 400 ML
With a ready indicator. When the appliance is connected to power supply, turn on the
power switch, after 25s the mop start to emit the steam
The angle of the rotation axis in the cleaner is greater；
1. Water Tank Release Button
2. Detachable Water Tank
3. Power Cord Organizer (bottom)
4. Assembly Screw (x1)
5. Carpet Glide
6. Microfiber Pads (x1)
This product is NOT for space heating purposes.
IMPORTANT:
Using Your Steam Mop-Operating Instructions
Insert screw into the hole;
tighten using a flat-head
screwdriver.
Press Water Tank Release
but- ton and remove water
tank.
Press Water Tank Release
but- ton and remove water
tank.
Tighten cap, insert tank
(cap down) until it “clicks”.
Press ON/OFF button. Wait 25
seconds for unit to heat up unit
may vibrate while heating.
Gently place unit on microfiber
pad. You are now ready to
steam clean.
Tilt handle at a 45º angle.
Push and pull slowly across
the floor to clean thoroughly.
When done, push ON/OFF
button
When unit has cooled, remove
microfiber pad. Store unit upright
in a dry area.
IMPORTANT:
Always empty the water tank once you have finished using your appliance.
IMPORTANT: Vibration Sound
While the unit is turned off, air builds up in the water pump line. This is a common accurance.
When the unit is turned on the water pump pushes air out of the line and emits a vibrating
sound. This occurs while the unit is heating up and also when the water tank is emptied during
use. If the vibration sound persists for more than 60 seconds during heat up, check to make
sure the water tank is assembled correctly.
Floor Setting Button：
Use this button to switch between two steam levels,
each catering to specific floor types.
Floor Setting Indicator Light:
This light indicates which steam floor setting level is
selected.
High steam emission ideal for ceramic, stone, tile
and other durable floors.
Gentle steam emission perfect for sealed
hardwood, laminate, bamboo and other delicate
floors.
Using the Carpet Glide
What is the Carpet glide?
The carpet glide enables the steam mop to be used on softer surfaces including carpets,
rugs, upholstery and pet bedding. The steam mop is designed to kill dust mites and other
allergens. Please check the labels on upholstery particularly rugs before using this
appliance on them.
Attach carpet glide by placing
unit under “tabs” and gently
pushing down into place.
Turn unit off, let cool. Use foot on
“Hands free” tab to remove Tray
from steam head
Turn unit on, slowly move unit
back and forth over stain.
Problem
Solution
Vibration sound last
longer than 60 seconds.
•
Add water to the water tank.
•
Ensure that water tank is inserted correctly in unit.
Unit not operating.
•
Ensure plug is set firmly in outlet.
•
Check and replace the fuse.
Unit does not emit steam.
•
Ensure water tank is filled with water.
Water left on floor.
•
Change the microfiber pad.
•
Ensure unit is always level and parallel to the floor.
White spot left on floor.
•
When cleaning do not leave unit in one spot for too long.
•
Use protector pad / floor mat when unit is ON and
stationary.
•
Use distilled water instead of hard tap water.
•
NOTE: To remove any spots, use a damp cloth and a
small amount of white vinegar.
Troubleshooting
Here are some handy tips to follow if you experience any issues with this appliance.
CAUTION! ENSURE THE UNIT IS DISCONNECTED FROM THE MAINS AND HAS
COMPLETELY COOLED DOWN BEFORE PERFORMING ANY TROUBLESHOOTING
CHECKS OR MAINTENANCE.
Warranty Registration
To register you free one year Vytronix warranty visit www.vytronix.com using product
code: brandnew-vytronix-R4SFL
If you have any queries or require assistance with using your product including set up,
troubleshooting or registration please email our customer care on support@vytronix.com
Safe Disposal
This marking indicates that this product should not be disposed
with other household waste throughout the EU. To prevent
possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote
the sustainable reuse of material resources. To arrange safe
disposal of your used device, please use the return and
collection systems or contact the retailer where the product was
purchased.
If you have any queries or require assistance with using your
product including set up, troubleshooting or registration please
email our customer care on support@vytronix.com
Register your warranty at www.vytronix.com
/
