shopify DC Accessory Relay System Wiring Cable User guide

Text

DC Relay

Battery 1 (+) +9VDC to +30VDC Power

Installation Instructions:

1. Connect black relay wire to Relay Control 1 (purple) or Relay Control 2 (white) on the wiring cable.

2. Connect orange relay wire to accessory.

3. Connect blue relay wire to +12VDC power.

4. Connect red relay wire to +12VDC power.

Note: The red and black wires connect to the coil side of the relay. The blue and orange wires connect to the

switch side of the relay. This relay is required if the draw on the Siren 3 Series output exceeds 1 Amp. This relay

can draw up to 10 Amps.

Product SKU: SM-ACC-DCRE

Note: Posi-Tap? connectors, terminal

block, or other connection type can be used

to connect the wiring cable to sensor wires.

DC Common

Ground (-)

Relay Control 2

Relay Control 1

+12VDC Power

DC Accessory such as

lighting, or audible alarm/siren

+12VDC Power

Wiring Cable 1

DC Accessory Relay

Note: The DC Relay can be

connected to either Relay

Control 1 (purple) or Relay

Control 2 (white) on the

wiring cable.

DC Common

Ground (-)

Download PDF