Nex 720-0140-LP Owner's manual

STAINLESS STEEL GAS GRILL

USE AND CARE GUIDE

MODEL NO.: 720-0140-LP

®

FOR OUTDOOR USE ONLY

PLEASE CONTACT 1-800-790-1299 FOR ASSISTANCE

MESSAGE TO OUR CONSUMERS

Thank you for selecting our stainless steel gas grill.

Because this appliance contains features which may not found on other grills, we recommend

that you read this entire booklet before your first use. Keep it in a handy place as it has

answers to questions that may occur during future use.

Please read this booklet carefully and be sure your gas grill is properly assembled, installed and

maintained. Failure to follow these instructions could result in serious bodily injury and/or property

damage. This gas grill in intended for outdoor use only and is not intended to be installed in or on

recreational vehicles or boats.

NOTE TO INSTALLER: Leave these instructions with the consumer after installation.

NOTE TO CONSUMER: Retain for future reference.

TABLE OF CONTENTS

SECTION FIVE

Care and maintenance …………………. 28

Lighting Illustration…………………… 29

To match light the grill………………….31

Care and maintenance……………… ….32

Troubleshooting ……………………….. 32

SECTION SIX

Enlarge view …………………….…….. 34

Parts list ……………………………….. 35

Ordering parts ………………………….. 36

Grill hints ………………………………. 36

SECTION SEVEN

Grill cooking chart …………………… 37

SECTION EIGHT

Grill recipe suggestions ……………….. 40

SECTION NINE

Warranty ………………………………. 43

SECTION ONE

Precaution ……………………………. 1

Placement of the grill ………………… 3

SECTION TWO

Assembly check list ………………….. 4

Assembly instructions ………………... 7

SECTION THREE

Gas hook-up ………………………… 21

Leak testing ……….……………….....23

Installer final check list ………………23

Propane tank assembly……………….24

Operation instructions ………………..25

Grill lighting instructions …………… 26

SECTION FOUR

Using side burner …………………… 27

PRECAUTIONS

FOR YOUR SAFETY

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flames.

3. Open lid.

4. If odor continues, immediately call

your gas supplier.

CALIFORNIA PROPOSITION 65-

WARNING

The burning of gas fuel generates some by-

products, which are on the list of substances,

which are known by the State of California to

cause cancer or reproductive harm. California

law requires businesses to warn customers of

potential exposure to such substances. To

minimize exposure to these substances, always

operate this unit according to the use and care

manual, ensuring you provide good ventilation

when cooking with gas.

WARNING

Do not try to light this appliance without

first reading the “LIGHTING

INSTRUCTIONS” section in this manual.

SAFETY PRACTICES TO AVOID

PERSONAL INJURY

When properly cared for, your stainless steel

grill will give safe, reliable service for many

years. However, extreme care must be used

since the grill produces intense heat and that

can increase accident potential. When using

this appliance basic safety practices must be

followed, including the following:

Read this Care and Use Manual carefully and

completely before using your grill to reduce the

risk of fire, burn hazard or other injury.

Do not repair or replace any part of the grill

unless specifically recommended in this manual.

All other service should be referred to a

qualified technician.

CHILDREN SHOULD NOT BE LEFT

ALONE OR UNATTENDED IN AN AREA

WHERE THE GRILL IS BEING USED.

NEVER ALLOW THEM TO SIT, STAND OR

PLAY ON OR AROUND THE GRILL AT

ANY TIME.

FOR YOUR SAFETY

1. Do not store or use gasoline or other

flammable vapors and liquids in the

vicinity of this or any other appliance.

2. An LP cylinder not connected for use

shall not be stored in the vicinity of

this or any other appliance..

TESTED IN ACCORDANCE WITH ANSI

Z21.58 / CGA 1.6 STANDARD FOR

OUTDOOR COOKING GAS

APPLIANCES. THIS GRILL IS FOR

OUTDOOR USE ONLY.

Check your local building codes for the

proper method of installation. In the absence

of local codes, this unit should be installed in

accordance with the National Fuel Gas Code

ANSI Z223.1/NFPA 54, ANSI/NFPA 58 OR

CGA B149.1 Natural Gas and Propane

Installation Code, and the National Electrical

Code, ANSI/NFPA 70, or the Canadian

Electrical Code, CSA C22.1.

1

PRECAUTIONS

DO NOT STORE ITEMS THAT ATTRACT

CHILDEN AROUND OR BELOW THE

GRILL OR IN THE CART. NEVER ALLOW

CHILDREN TO CRAWL INSIDE OF THE

CART.

Never let clothing, pot holders or other

flammable materials come in contact with or

too close to any grate, burner or hot surface

until it has cooled. Fabric may ignite and

result in personal injury.

For personal safety, wear proper apparel.

Loose fitting garments or sleeves should never

be worn while using this appliance. Some

synthetic fabrics are highly flammable and

should not be worn while cooking.

Only certain types of glass, heat-proof glass

ceramic, earthenware, or other glazed utensils

are suitable for grill use. These types of

materials may break with sudden temperature

changes. Use only on low or medium heat

settings according to the manufacturer’s

directions.

Do not heat unopened food containers as a

build-up of pressure may cause the container

to burst.

Use a covered hand when opening the grill lid.

Never lean over an open grill.

WHEN LIGHTING A BURNER, ALWAYS

PAY CLOSE ATTENTION TO WHAT YOU

ARE DOING. BE CERTAIN YOU ARE

TURNING THE IGNITER LABELED FOR

THE BURNER YOU INTEND ON USING.

When using the grill, do not touch the grill

rack, burner grate or immediate surroundings

as these areas become extremely hot and

could cause burns. Use only dry potholders.

Moist or damp potholders on hot surfaces may

cause burns from steam. Do not use a towel or

bulky cloth in place of potholders. Do not let

potholders touch hot portions of the grill rack.

Grease is flammable. Let hot grease cool before

attempting to handle it. Avoid letting excess

grease deposits collect in the grease tray at the

bottom of the grill’s firebox. Clean often.

DO NOT USE ALUMINUM FOIL TO LINE

THE GRILL RACKS OR GRILL BOTTOM.

This can severely upset combustion air flow or

trap excessive heat in the control area.

For proper lighting and performance of the

burners keep the burner ports clean. It is

necessary to clean them periodically for

optimum performance. The burners will only

operate in one position and must be mounted

correctly for safe operation.

Clean the grill with caution. Avoid steam burns;

do not use a wet sponge or cloth to clean the

grill while it is hot. Some cleaners produce

noxious fumes or can ignite if applied to a hot

surface.

INSECT WARNING!!! Spiders and insects can

nest in the burners of this and any other grill,

and cause the gas to flow improperly. This is a

very dangerous condition which can cause a

fire to occur behind the valve panel, thereby

damaging the grill and making it unsafe to

operate. Inspect the grill twice a year.

Be sure all grill controls are turned off and the

grill is cool before using any type of aerosol

cleaner on or around the grill. The chemical

that produces the spraying action could, in the

presence of heat, ignite or cause metal parts to

corrode.

2

PRECAUTIONS

Do not use the grill for cooking excessively

fatty meats or products which promote flare-

ups. Do not operate the grill under unprotected

combustible construction. Use only in well

ventilated areas. Do not use in buildings,

garages, sheds, breezeways or other such

enclosed areas. THIS UNIT IS FOR

OUTDOOR USE ONLY.

Keep the area surrounding the grill free from

combustible materials, trash, or combustible

fluids and vapors such as gasoline or charcoal

lighter fluid. A minimum of 24” clearance

away from combustible material. Do not

obstruct the flow of combustion and

ventilation air. If the unit is stored indoors

ensure that it is cool. If propane is used, the

cylinder must be unhooked and the propane

cylinder stored outside in a well ventilated

area, out of the reach of children.

DO NOT USE BRIQUETTES OF ANY KIND

IN THE GRILL.

This stainless steel grill is designed for

optimum performance without the use of

briquettes. Do not place briquettes on the

radiant as this will block off the area for the

grill burners to vent. Adding briquettes can

damage ignition components and knobs, and

void the warranty.

Keep the back of the cart free and clear from

debris. Keep any electrical supply cord, or the

rotisserie motor cord away from the heated

areas of the grill.

Never use the grill in extremely windy

conditions. If located in a consistently windy

area (oceanfront, mountaintop, etc.) a

windbreak will be required (see below). Always

adhere to the specified clearance.

NEVER USE A DENTED OR RUSTY

PROPANE TANK.

PLACEMENT OF THE GRILL

Locate the grill only in a well-ventilated area. Never

locate the grill in a building, garage, breezeway,

shed or other such enclosed areas without an

approved ventilation system. During heavy use, the

grill will produce a lot of smoke. After the grill is

placed in a suitable position, lock the wheels

according to the sticker located beneath the right

door. Keep any electrical supply cord and the fuel

supply hose away from any heated surfaces.

Storage of an outdoor gas cooking appliance indoor

is permissible only if the cylinder is disconnected

and removed from the appliance.

This outdoor cooking gas appliance shall be used

only outdoors and shall not be used in a building,

garage or any other enclosed area. This appliance is

not intended to be installed on recreational vehicles

and/or boats.

3

CLEARANCE

To Non-Combustible Construction

A minimum of 3” clearance from the back of

the grill to non-combustible construction is

required for the lid to open fully.

DO NOT INSTALL THIS UNIT INTO

COMBUSTIBLE ENCLOSURES!

LOCATION

When determining a suitable location take

into account concerns such as exposure to

wind, proximity to traffic paths and keeping

any gas supply lines as short as possible.

ASSEMBLY CHECK LIST

Castors

4

Item Description Parts QTY Check

1

Left Side Panel

Right Side Panel

Back Panel

Right Door

Left Door

Bowl Assembly

Bottom Panel

with Gas Tank Tray

TOOLS REQUIRED: PHILIPS HEAD SCREWDRIVER—NOT PROVIDEDTHE

FOLLOWING HARDWARE IS PROVIDED

4

Side Burner Bowl

Assembly

Side Shelf Bracket

Side Shelf

Push Bar

Rotisseries Kit

With Motor

Motor Bracket

Cooking Grids

Flame Tamer

Warming Rack

Heat Shield

4

1

5

3

1

4

1

Hooks

Cart Frame

5

L Wrench

Spice Tray

Lighting Rod

Hardware Packe A

Hardware Packe B

Hardware Packe C

2

1

6

ASSEMBLY INSTRUCTIONS SIDE SHELVE

PLEASE READ THE INSTRUCTIONS THROUGHLY AND FOLLOW STEP

BY STEP.

HARDWARE PACK DESCRIPTION SPECIFICATION QUANTITY

A TRUSS HEAD SCREW 5/32”X12MM 14PCS

SPLIT LOCK 5/32”

14PCS

LOCK WASHER

14PCS

B TRUSS HEAD SCREW 1/4”X12MM

30PCS

SPLIT LOCK 1/4”

30PCS

LOCK WASHER

30PCS

C TRUSS HEAD SCREW 1/4”

X19M 18PCS

SPLIT LOCK 1/4”

18PCS

LOCK WASHER

18PCS

REMARK: EXTRA 2 MORE PICECS IN EACH HARDWARE PACK.

WRENCH: USED FOR STEP 10 SIDE BURNER VALVE ASSEMBLY.

Pack A Pack B Pack C

STEP 1: Remove bottom panel and four casters from the carton. Use 16 pcs of truss

head 1/4”x19mm screw and 16 pcs of 1/4”split lock and lock washer (pack C) to lock

two casters (in the right side of bottom panel) and two casters with brake (in the left

side of bottom panel) to the bottom panel.

7

Pack C

STEP 2: Use 4 pcs of truss head 5/32”x 12mm screw and 4 pcs of split lock

and 4 pcs of lock washer(pack A), then attach the left and right side panels

to the bottom panel as shown figure below. When installing the right and

left panel, the flat side must face outside.

STEP 3: Assemble back panel to bottom panel with 3 pieces of truss head

5/32” x12mm screw and 3pieces of 5/32” split lock and 3 pieces of lock washer

(Pack A). When installing the back panel, the flat side must face outside.

Pack A

Base

Back Panel

R

L

ASSEMBLY INSTRUCTIONS

8

ASSEMBLY INSTRUCTIONS

STEP 6: Place the upper portion of grill on to the cart, align with the side

panels. Then assemble it with the cart using 4 pcs of 1/4”x12mm head screw

and split lock and lock washer.(pack B).

NOTE:Tighten all screws before processing.

3

D

A

0

2

7

B

Pack B

10

ASSEMBLY INSTRUCTIONS

STEP 9 :Use 2 truss head 1/4”x12mm screw with 2 split lock and 2 lock wahser

(pack B) to tight the side shelf and the spice tray. See figure below.

Pack B

STEP 10 :Use 4 truss head 1/4”x12mm screw with 4 split lock and 4 lock

wahser (pack B) to attach the side burner bracket. See figure below.

12

Step:13 Side burner valve assembly:

ASSEMBLY INSTRUCTIONS

Step 1: Insert valve assembly through side Step 2: Remove 4(four) screws & washers

panel from the “U” brackets on the side

(Side panel, right) burner.

Step 3: Insert valve stem assembly into burner Step 4: Insert valve stem assembly into

tube. face-plate.

14

ASSEMBLY INSTRUCTIONS

Step 5: Replace “U” brackets with 4(four) Step 6: Align & tighten knob seat & valve

Screws( DO NOT TIGHTEN) stem with 2(two) screws & washers

Note:(Make sure hose is not bent) as shown below.

Step 7;Tighten all 4(four) screws on the “U” Step 8: Place knob on valve stem and secure

brackets on the burner, then connect with the wrench tool.

the ignition wire on to valve.

(wrench tool enclosed in bag)

Valve Stem

Knob Seat

Ignition wire

**Important Note! Make Sure Side Burner Hose Is not Bent**

15

ASSEMBLY INSTRUCTIONS

STEP 18: Place the flame tamers, cooking grids and the warming rack into the

grill. Then insert the grease try.

18

Page is loading ...

Nex 720-0140-LP Owner's manual

This manual is also suitable for

Nex 720-0140-LP Owner's manual

Related papers

Other documents