PDi All Arms Installation guide

Brand
PDi
Model
All Arms
Type
Installation guide
MODEL NUMBER:
Arm Mounted PDi TV
Document Number:
PD196-428R
Installation Instructions
Page 1 of 2
PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ www.pdiarm.com and www.mymedTV.com ▪ Phone 800.628.9870
INTRODUCTION
This document provides the information to install any arm mounted PDi TV with top mount. These instructions
cover the standard design of the arm mounted PDi TV with top mount and any customizations incorporated
may not be specifically outlined in these instructions.
Note: For Rear Mounted TV’s see the specific Installation Instruction for the mount.
SAFETY
1. Always wear safety glasses/goggles to prevent injury from debris.
2. Follow the installation/removal instructions for your existing products.
TOOLS REQUIRED
1. 3/16” hex wrench
2. Safety glasses/goggles
INSTALLATION
DANGER: ARM RECOIL HAZARD. The safety brake pin must remain
in the SAFETY BRAKE PIN HOLE whenever the television set is
removed from the arm or when the arm is removed from the wall
bracket to prevent the arm from springing open.
1. Remove PDi TV from the box. Be sure to save the foam inserts and the box as they will be needed if you
ever need to return your PDi TV.
Note: Store the monitor as shown when not mounted on the arm.
MODEL NUMBER:
Arm Mounted PDi TV
Document Number:
PD196-428R
Installation Instructions
Page 2 of 2
PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ www.pdiarm.com and www.mymedTV.com ▪ Phone 800.628.9870
2. Remove screw PDISHCS252075 and retaining washer PD220-002. Discard the washer PD220-002 and
place screw PDISHCS252075 to the side.
3. If they have been installed, remove the nose covers for the PDi swing arm. See Arm Installation
Instructions for additional details.
4. Slide the PDi TV into the nose so that mounting washer fits inside the slot in the nose, the retainer plate
rests inside the nose and the hole in the retainer plate aligns with the mounting hole of the nose. Install
screw PDISHCS252075 in the mounting hole.
5. Connect the cables from the arm to the PDi TV as required, be sure to follow all appropriate safety
procedures for working with the cables.
6. Re-install the covers for the PDi swing arm. See Arm Installation Instructions for additional details.
WARRANTY
PDi Communication Systems, Inc., (“PDi”) standard warranty information is found at pdiarm.com. For information
regarding authorized servicing and all other information pertaining to this warranty, please
contact PDi COMMUNICATION SYSTEMS, INC. at 40 Greenwood Ln, Springboro, Ohio 45066 or phone 800-
628-9870 and ask for the PDi ProServices team.
  • Page 1 1
  • Page 2 2

PDi All Arms Installation guide

Brand
PDi
Model
All Arms
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents