2. Pepperl+Fuchs
  3. IUA-F860-FR1

Pepperl+Fuchs IUA-F860-FR1, IUA-F860-FR2 Operating instructions

  • I have reviewed the mounting instructions for the Pepperl+Fuchs IUA-F860-FR antenna. The document provides guidelines for mounting the device outdoors using M5 screws, securing it with an eyebolt and wire rope, and maintaining its performance by adhering to cable bending radius specifications and protecting its pressure compensation element. I am ready to answer your questions about this device.
  • What type of screws should be used for mounting?
    What is the maximum screw-in depth?
    What is the minimum bending radius of antenna cable?
© Pepperl+Fuchs · Subject to modifications / DOCT-8645 - 2023-05
Brief Instructions
IUA-F860-FR* Mounting Instructions 1
Refer to "General Notes Relating to Pepperl+Fuchs Product Information"
Pepperl+Fuchs Group Tel: +49 621 776-0
www.pepperl-fuchs.com E-Mail: inf[email protected].com
IUA-F860-FR* Mounting Instructions
Mounting
The antenna is designed to be mounted outdoors. Four holes for M5 screws are provided on the backside of the housing for
mounting on a VESA bracket. The screws used should have a screw-in depth of maximum 12 mm (0.45"). For secondary protec-
tion the antenna can be secured with an eyebolt, see Fig. 1. Fix the eyebolt with threadlocker. Secure the antenna e.g. with a wire
rope.
You can find suitable accessories at Pepperl-Fuchs.com
Figure 1 Back view
Figure 2 Side view
Warning!
Damage, loss of performance
The minimum bending radius of the antenna cable of 22 mm static and 44 mm dynamic must not be exceeded to avoid damage
and reduction of the antenna performance.
In order to maintain the full protection class and to prevent loss of performance of the antenna, the pressure compensation ele-
ment must not be damaged under any circumstances.
/