Amada AMPS02 User manual

Brand: Amada

Model: AMPS02

Type: User manual

Phillips

Screwdriver

(Not Included)

Tripod Stand Instruction Manual

V1.0(B)

Model: AMPS02

Step 2 Secure the Connector to the Top of the Tray Support Leg

Step 3 Secure the Tray to the Connector

Step 4 Tilt and Height Adjustment

04 05

Note:

● The holes in the connector should be aligned with the holes on the

tray.

● Do not tighten the bolts [D] until all of them are in right positions.

Height Adjustment of Tray Support Leg

1. Remove the safety pin [M] from the

tray support leg.

2. Slightly loosen the height adjustment

knob [N] for better to adjust the height.

3. When you adjust the tray support leg

to your desired height, tighten the knob

[N] and insert the safety pin [M] into the

hole of the tray support leg.

Height Adjustment of Tripod Stand

1. Slightly loosen the height adjust-

ment knob [O] for better to adjust the

height of the tripod stand.

2. When you adjust the tripod stand to

your desired height, tighten the knob

[O] to secure the height in place.

Tilt Adjustment of Tray

Slightly loosen the tilt adjustment knobs

[K] for better to adjust the height. When

you adjust the tray to your desired tilt

angle, tighten the knobs [K] to secure

the height in place.

Tighten the knob

Thank you for choosing this AMADA product! At AMADA we strive to provide

you with the best quality products and services in the industry. Should you

have any issues, please don't hesitate to contact us at

[email protected]

• Check package contents against supplied parts and hardware list to assure

that all components were received undamaged. Do not use damaged or

defective parts. lf you require replacement parts, please contact amada

customer service at [email protected].

• Carefully read all instructions before attempting installation. If you do not

understand the instructions or have any concerns or questions, please

contact customer service at [email protected].

• Not all parts and hardware included will be used.

• Do not use this product for any purpose that is not explicitly speciﬁed in

this manual. We cannot be liable for damage or injury caused by incorrect

assembly or inappropriate use. Thank you for your understanding.

IMPORTANT SAFETY INFORMATION

Supplied Parts and Hardware

Speciﬁcation

Tray

B (x1)

Connector

C (x1)

M4x10 mm

Bolt

D (x4)

Step 1 Adjust the Height of the Tripod

01 02 03

Height Adjustable

Foldable Tripod Stand

A (x1)

Slightly loosen the knob.

1-2

1-1

When you adjust the pillar to your desired

height, tighten the knob, then insert the

safety pin into the hole on the pillar.

Phillips

Screwdriver

(Not Included)

Warning: When you unfold or

fold the tripod, please be careful and

avoid pinch areas such as the upper

section of the supporting leg. DO

NOT place hands on or near the

joints of the supporting leg.

Height Adjustable

26 in - 51 in

(660 mm - 1295 mm)

16.0 in

（406 mm）

11.0 in

（280 mm）

Loosen

Tighten

Amada AMPS02 User manual

Amada AMPS02 User manual

Other documents