Rev: 03/10/2021 Doc. #ZBI000037
Item #AHX000027
Attaching Flex-Hose
To help provide a secure and airtight t for your hose, Gasket (D) must
be applied to both ends of the Gated Tee-Joint (A).
Lay out the Gasket around one end of the Gated Tee-Joint and cut where
both ends mate. Peel the backer tape o the Gasket and adhere to one
end of the Gated Tee-Joint. e ends of the Gasket must meet to ensure
an airtight seal. Repeat on other end of the Gated Tee-Joint.
Pull the hose over each end of the Gated Tee-Joint and secure it in place
with the Turn-Key Hose Clamps (E).
Using the Reducers
e Gated Tee-Joint (A) includes two Reducers (B) (C) for connecting
various vacuum hoses to the gated branch. e reducers attach to the
branch using a friction t.
• e branch itself will accept raw 4" ex hose over it, held in place
with a Hose Clamp.
• e 4 to 2-1/2" Reducer (B) will accept any standard 2-1/2" vacuum
hose and assorted cus.
• e 4 to 1-1/2" Reducer (C) will accept any standard 1-1/2" vacuum
hose and assorted cus.
Note: In some rare cases, your hose cu may match the diameter of the
Reducer and will require a hose coupler to join the two ttings together.
Using the Blast Gate
To preserve airow performance, the blast gate should be closed o
when the tool connected to it is not in use.
When opening and closing the blast gate, the plate will hold its position
thanks to the internal magnetic brake.
Note: Your dust collector must always have at least one branch open
during operation to avoid "dead-heading" the system.
Wall-Mounting Instructions
Aer all of your ductwork has been connected and installed, the Tee-
Joint can be directly fastened to the wall for further stability and security.
Using a long bit driver extension for your power drill, insert through the
open gated branch and pre-drill a hole through the protrusion on the
side of the Tee-Joint and into the wall [FIG. 1].
Secure the Tee-Joint in place using a suitable screw, rubber washer, and
at washer to ensure a proper airtight seal within the duct.
Note: e remainder of your ducting should use its own wall-mounts and
not rely on the Tee-Joint for support. You must provide your own wall
mounting hardware.
Gated Tee-Joint Kit
Contact our Customer Service Department for further assistance
1-866-387-8822 • support@oneida-air.com • oneida-air.com/contact-us
1001WestFayetteStreet,Syracuse,NY13204U.S.A.•Copyright©2021OneidaAirSystems,Inc.
Recommended Tools:
• Power Drill
• Wall Mounting Hardware
• 8" Drill Bit Extension
ID Part Number Part Description Qty
A DMT040422 Gated Tee-Joint 1
B ———— 4 to 2-1/2 Reducer 1
C ———— 4 to 1-1/2 Reducer 1
D RGZ125075 Gasket 6 ft.
E ACB640000 Turn-Key Hose Clamp 3
B
D
AC
E
FIG. 2
FIG. 1
Wall
/
