2. Dometic
  3. AE Systems Two Step Awning Stand Off Bracket Kit 3108708.086

Dometic AE Systems Two Step Awning Stand Off Bracket Kit 3108708.086 Installation guide

  • I have reviewed the installation instructions for the A&E Systems Awning Standoff Bracket 3108708.086. This document provides step-by-step guidance on how to install the standoff brackets and foam spacers. The kit is designed to create a 1/2 inch gap between the awning hardware and sidewall. I'm ready to answer your questions.
  • What does this kit do?
    What components are included in the kit?
    Where should the foam spacers be placed?
Form No. 3108687.009 2/99
©1999 The Dometic Corporation
LaGrange, IN 46761
Installation Instructions
Kit, Two Step Awning Stand Off Bracket
Part No. 3108708.086
For 76000XX.4XX Hardware
This Kit Contains:
4 - 3104954.007 1/2" Standoff Brackets
6 - 3108708.094 1/2" Foam Spacer
1 - 3108687.009 Installation Instructions
Important: Read and understand all of the following
steps before beginning installation.
This kit will properly space the hardware 1/2" away from the
sidewall when clearance is needed for trim, windows, etc.
Follow the Installation Instructions provided with the hard-
ware and add the following steps for stand off bracket instal-
lation.
1.Before installing hardware, place the 6 self adhesive
styrofoam spacers on back channel as shown in FIG. 1.
Place middle spacer directly behind strut bracket. If win-
dows or other items do not allow positioning as shown,
place middle spacer as close as possible.
2.While installing the top mounting bracket, place one
standoff bracket behind the top mounting bracket as
shown in FIG. 1. Repeat for other side.
3.The two additional stand off brackets will be put into po-
sition prior to installing the bottom mounting brackets.
See FIG. 1.
FIG. 1
twostep
/