optonica 2835 User manual

Hello! I have reviewed the user manual for the OPTONICA LED strip light RUNNING WATER STRIP. This document provides guidelines on installation, power supply selection, and connecting the strip with a controller. I'm ready to assist you with questions about this device, like how to properly connect the strip with power supply and controller, or other topics from the document.
What should I do before starting the installation?

How should I choose a power supply?

What is the maximum length of strip light to be connected in series?

How to connect multiple strip lights together?

USER MANUAL

RUNNING WATER STRIP

HOW TO CONNECT STRIP WITH POWER SUPPLY AND CONTROLLER

1. Please check the luminaire carefully before the installation.

2. Ensure the power is off before wiring and installation.

CHECK POINTS:

TIPS

1. Please be kindly informed that the total wattage of LED strip lights should not exceed the max wattage of the

adapter you chose.

2. All the adapters mentioned in this User Guide have only one DC output terminal. Thus they can only be used

for one single strip light or a strip connected in series.

3. To guaranty the lighting uniformity of both the front and the end of the strip light, please do not connect the

led strip light more than 10m.

4. If you want to use several strip lights together, please connect them in parallel and choose another adapter

with more than one output terminal.

HOW TO CHOOSE A POWER SUPPLY:

IMPORTER: Prima Group 2004 LTD, Bulgaria, 1784 Soﬁa, Mladost 1, bl. 144, Ground Floor; Phone: +359 2 988 45 72;

HOW TO CONNECT MANY PIECE STRIP CHANGE MODE AT SAME STEP

Connect the strip to the ampliﬁer ( please make sure to connect with correct wire, if there is connector on strip,

just cut off connector), connect the controller to the ampliﬁer, connect the power adapter to the ampliﬁer.

Power on and enjoy it.