Gronomics VWEGB 24-33, VWEGB24-33WS Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Gronomics VWEGB 24-33 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
www.gronomics.com East Bethel, MN USA
763-753-7374
Vinyl Wrapped Elevated Garden Bed
(24” x 33”) Assembly Instruction
Continued
Parts List
ITEM QTY. PART # DESCRIPTION
1 4 VW3000E
Corner Post, 2-3/4" x 2-3/4" x 30"
2 1 VW3100L
Side Rail w/Logo, 31" x 4-1/4" x 1"
3 3 VW3100
Side Rail, 31” x 4-1/4" x 1"
4 2 VW3102
Side Rail w/Cleat, 31" x 4-1/4" x 1"
5 6 VW2100
Side Rail, 21” x 4-1/4" x 1"
6 5
Bottom Board, 20-3/4" x 5-1/2 x 1"
7 1 FL2236 Fabric Liner 22” x 36”
8 4 VWCAST Caster
91
R49-114ZY, CS8-114ZY Hardware Bag, (Qty: (48) R49-114ZY & Qty: (12) CS8 - 114ZY)
10
4
11
2
VW3030
Caps
Wooden Block 90°
1
2
6
4
3
5
7
8
11
Stack matching pieces in piles. Using the parts list, locate
and count the individual pieces and verify that you have
received the correct number of pieces.
If any pieces are missing or replacement parts are required,
contact Gronomics at 1-855-299-6727.
NOTE: It is recommended to place a protective layer
between the ground and the pieces during assembly. This
will help prevent damage to the pieces.
Parts Identification Box 1
Item #: VWEGB 24-33
1
Packaged & Inspected by: Date:
2034BB
9
10
www.gronomics.com East Bethel, MN USA 763-753-7374
Continued
Parts List Box 2 (Optional)
ITEM QTY. PART # DESCRIPTION
12
1 VWSH31 Shelf 22” x 31”
12
If any pieces are missing or replacement parts are required,
contact Gronomics at 1-855-299-6727.
NOTE: It is recommended to place a protective layer
between the ground and the pieces during assembly. This
will help prevent damage to the pieces.
Parts Identification Box 2 (Optional)
2
Locate the four 30” corner posts (Item 1).
NOTE: Each corner post has one end with three pre-drilled
holes. This is the bottom of the corner post.
Side Rail Assembly
3
1
Tongue
Up
1 1
2
Wooden Block and
Top of Side Rail
Flush
Wooden Block and
Top of Side Rail
Flush
11 11
11
9
9
Place the corner posts (Item 1) as shown.
Place the 31” side rail (w/Logo) (Item 2), logo face down,
with side rail ends tight to inner corner posts.
Place a 90° wooden block (Item 11) as shown to set the
heig
ht for the top side rail. Top of corner post and top of
wooden block flush.
Install two screws (Item 9) from hardware bag into
the two pre-drilled holes at each end of the side rail,
where each screw is flush with side rail.
Side Rail Assembly Continued
4
Note: Do not over tighten screws.
www.gronomics.com East Bethel, MN USA 763-753-7374
Continued
9
3
4
9
Install a 31” side rail (Item 3) and slide upward until the
tongue and groove is fully seated with the upper side rail.
Install two screws (Item 9) into each end of the side rail.
Install a 31”side rail (w/cleat) (Item 4) and slide upward until
the tongue and groove is fully seated. Install two s
crews
(Item 9) into each end of the side rail (w/cleat).
Repeat steps 4 and 5 for the opposite side rail assembly.
Side Rail Assembly Continued
5
5
9
9
Locate three 21” side rails (Item 5) and install side rails
facing inner edge of each corner post, keeping upper edge
of top side rail flush with mark on corner post.
Install two screws (Item 9) from hardware bag into the
three pre-drilled holes in each end of eac
h side rail.
Repeat this step to assemble opposite end.
Side Rail Assembly Continued
6
Tip the box assembly upside down and place four casters
(Item 8) onto the bottom of each corner post, install three
screws (Item 9) into each caster/corner post.
Caster Assembly
7
8
9
www.gronomics.com East Bethel, MN USA
763-753-7374
Continued
6
7
Tip the box assembly upright and install the bottom boards
(Item 6), space evenly.
Install liner (Item 7) into bottom of box.
Bottom Boards and Fabric Assembly
8
10
Install caps (Item 10) on each corner post.
Cap Installation
9
www.gronomics.com East Bethel, MN USA 763-753-7374
12
Install the shelf (Item 12) (if applicable) inside the corner
posts and rest the shelf on the caster wheel brackets.
Bottom Shelf Installation (Optional)
10
Place the garden bed on it’s side and install a screw if you
choose to through each cas
ter wheel bracket into shelf.
Bottom Shelf Installation (Optional) Continued
11
(Screws are not provided)
/