GS-1-HM
1
2
A DIVISION OF BEA SA | LIEGE SCIENCE PARK | ALLÉE DES NOISETIERS 5 - 4031 ANGLEUR [BELGIUM]
©BEA | Original instructions | 42.8453 / V1 - 12.14
BEA hereby declares that the GS-1-HM is in conformity with the basic requirements and the other relevant provisions of the
directives 1999/5/EC, 2006/95/EC and 2011/65/EU.
Angleur, December 2014 Pierre Gardier, Authorized representative
For EC countries: according to the directive 2012/19/EU for Waste Electrical and Electronic Equipment (WEEE)
Specifications are subject to changes without prior notice- Measured in specific conditions
TECHNICAL SPECIFICATIONS
DESCRIPTION
ENGLISH
Motion module for high mounting
1. radar antenna (9-patch)
2. connector (4 pins)
Technology:
Microwave transceiver:
Transmitter frequency:
Transmitter radiated power:
Transmitter power density:
Detection mode:
Detection zone:
Supply voltage:
Supply frequency:
Max power consumption:
Output:
Angle adjustment:
Temperature range:
Dimensions:
Cell material:
Weight:
Cable lenght:
Norm conformity:
microwave doppler radar
resonant cell
24.150 GHz
< 20 dBm EIRP
< 5 mW/cm²
motion
5 m x 5 m (typ) @ 5 m with angle of 30°
5 V DC +/- 5% regulated and filtered
DC only
< 1 W
2 sinusoïdal signals in quadrature
from 20° to 40°
from -20 °C to + 55 °C
30 mm (L) x 30 mm (H) x 40 mm (W)
zamak
60 g
6 cm
R&TTE 1999/5/EC, LVD 2006/95/EC, RoHS 2 2011/65/EU
The GS-1-HM is a radar module intended to be integrated in a sensor developped by a third
party. Other use of the device is outside the permitted purpose and can not be guaranteed
by the manufacturer. The manufacturer cannot be held responsible for incorrect installations or
inappropriate adjustments.
Please keep for further use
Designed for colour printing
RED 5V DC supply
BLACK GND
BLUE Schottky 2 signal
YELLOW Schottky 1 signal