Elizabethan Classics ECTW39 CP Installation guide

Elizabethan Classics
Brand
Elizabethan Classics
Model
ECTW39 CP
Category
Sanitary ware
Type
Installation guide

This manual is also suitable for

Assembly Instructions for TW36-40
NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS
1. Shut off the water supply valves before installation.
2. Insert the faucet through the two holes in the tub. Thread the Lock Nuts onto the threaded shanks
and tighten.
3. Connect the supply lines (sold separately) to the threaded shanks.
4. Install handles. After installation is completed, turn on the water supply valves and allow both hot
and cold water to run at least one minute each. While water is running, check for leaks,
especially at hook-ups to supply lines. Tightening nuts slightly will stop any minor leaks.
Lock Nut
Assembly Instructions for Handles
Lever Handles:
1. Be sure that the broach screws are tightened installing the lever handles.
2. Install the lever handles on the broaches and tighten the set screws using the allen
wrench provided.
before
Cross Handles:
1. Remove the screws from the top of the broaches.
2. Remove the insert caps from the cross handles.
3. Put the cross handles on the broaches and then tighten the screws. Insert the caps on the
cross handles.
Broach
Broach
Screw
Set
Screw
Allen
Wrench
Rev.D
Elizabethan
Classics
R
NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER
CAUTION: DO NOT OVER TIGHTEN NUTS AND SCREWS - THIS CAN LEAD TO
STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY.
  • Page 1 1

Elizabethan Classics ECTW39 CP Installation guide

Elizabethan Classics
Brand
Elizabethan Classics
Model
ECTW39 CP
Category
Sanitary ware
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents